Table of Contents
Advertisement
Using the Check button
Confirming the cooking time and Power Level in each Memory
Program
1. Clear all operations by pressing the Stop/Cancel(
button.
Press the Check button to enter Check mode.
2. By using Number buttons, enter the Memory Program
number from 1 to 20.
•
For example, suppose you press 5(
Program 5 which is HI power Level, I Stage cooking
with a time of 6 minutes and 30 seconds, 6:30.
•
First, 5 will be displayed, but will change to show the
Memory Program settings.
3. After one second, the display will clear automatically.
If you want to check other Memory Programs, just enter
the Memory Program numbers.
4. Press the Stop/Cancel(
)
), for Memory
) botton to exit the Check mode.
9
Reading each Memory Program's Cycle Counter
1. Clear all operations by pressing the Stop/Cancel(
button.
Press the Check button to enter Check mode.
2. Press the Start(
Number button, from 1 to 20, and the number of cycles for
that particular Memory Program will be displayed. The
cycle count is displayed in units of 10.
•
For example, if Memory Program 5 has been used 100
times, the display will show "10".
As the display uses units of 10, the cycle counts
are approximate. The cycle count displayed
increases every ten cycles.
For example, if the cycle count were 90-99, "9"
would be displayed, The "9" would change to
"10" on the 100th cycle. The cycle counter
function has a limit of 99,990 cycles. Once that
number is exceeded, the cycle counter will
automatically clear and start again from "0".
3. After one second, the display will clear automatically. If you
want to check the cycle count of other Memory Programs,
just enter the Memory Program numbers.
4. Press the Stop/Cancel(
mode.
)
+30s) button, and then press any
) button to exit the Checking
EN
Advertisement
Table of Contents
