Hama T568A Instruction Manual

Instruction Manual
Montageanweisung
2 a
Cut the end of boot to fit your cable OD.
3
Apply all four twisted
pairs according the
color code label
and allocate each
conductor into proper
slots on wiring cap. Keep the
cable length between the cable
sheath and the cable manager as short
as possible. Trim the ends of the conductors.
4
Place the wiring cap
onto plug , use plier to
clamp wiring cap until it
completely snap in to effect
the connection
5
Close plug cover,
make sure that the
drain wire (if available)
is in proper contact with
grounding clip on plug.
Pull back strain relief boot
to cover the plug, fasten
supplied cable tie to secure
grounding contact
6
Disassembly of the plug
Cut off cable tie, remove the boot.
Using flat screw driver and try
gently to open the plug.
Compact CAT 6a plug suitable for
Round solid cable AWG 23 – 26 (1 x 0,41 – 1 x 0,56 mm)
Stranded cable AWG 24- 26 (7 x 0.16 – 7x 0,20 mm)
TIA / EIA
T568A
1
white/green
green
2
3 white/orange
blue
4
5
white/blue
orange
6
7 white/brown
brown
8
2 b
Insert cable into strain
relief, strip off 30 mm of
the cable jacket, fold back
braid and drain wire
Wiring label
Drain Wire
Compatible to CAT 5, CAT 7, CAT 7a
TIA / EIA
1
T568B
white/orange
orange
white/green Remove cable tie
blue
before installation
white/blue
green
white/brown
brown
Hama GmbH & Co KG
86652 Monheim / Germany • www.hama.com
Cable tie
Open cap
00053790