WaterUps Corro Wicking Bed Assembly Manual

Step-by-Step Assembly Guide
for the WaterUps
This guide is designed to assist you with the assembly of your new WaterUps
About this Guide
The WaterUps ® Installa�on Guide has
detailed informa�on designed to cover
most types of WaterUps ®
and you can download a copy of it from
our website at www.waterups.com.au
This Guide contains addi�onal
informa�on specifically designed to
help you install your WaterUps
Wicking Bed.
Step-by-Step Assembly Guide for the WaterUps
What is in the kit?
The kit will come in 2 cardboard boxes.
Refer to the following list and the image
installa�ons below for details of the contents.
Box 1 will contain:
1. 6 x Corro long side panels, including
one panel with the hole for the
overflow pipe (565mm x 370mm);
® Corro
2. 4 x Corro short end panels
(415mm x 370mm);
3. 4 x Corro corner panels;
4. 2 x bags of nuts & bolts; and
5. 1 x rubber strip for the top of the bed.
Box 2 will contain:
6. 8 x WaterUps
7. 1 x WaterUps
liner insert;
8. 1 x WaterUps
9. 1 x outlet pipe screw fi�ng; and
10. 8 x cable �es.
®
Corro Wicking Bed
® Corro Wicking Bed
® wicking cells;
® black reservoir
® inlet pipe;
1
® Corro wicking bed.
Assembly Instruc�ons
1. Peel the protec�ve plas�c off the
corroguated wall panels.
2. Locate the panel with the hole for
the overflow pipe and place to one
side. Refer Figure 1.
Figure 1. Panel with hole for overflow
pipe. Note – the hole should be
posi�oned closest to the ground.
3. Now join the 3 long side panels with
the rounded Phillips head screw on
the (grey coloured) inside of the bed
and the nut and washer on the
(merino coloured) outside. Refer
Figure 2. At this stage only hand
�ghten the screws.
4. Join the 2 short end panels together.
Published: 4 February 2020