HAMPTON BAY 1000 000 000 Use And Care Manual page 14

Operation (continued)
15
Installing the Sliding Tube
□
Insert one end of the Sliding Tube (P2) into the Connector (P1),
attach the other end of the Sliding Tube (P2) to the Long Top
Bar (l1) by Bolt (AA).
NOTE: To avoid destroying the nish, please handle
it with care.
16
Installing the Big Top Panel
□
Install the Roof Panels starting from left to right. Slide #1 Roof Panel
(S1) into position. Then overlap #2 Roof Panel (T1) as shown and slide
it into position. Attach #1 Roof Panel (S1) and #2 Roof Panel (T1) to
#3 Roof Supports (O1) by Bolt (BB) and Spacer (X).
□
Slide #3 Roof Panel (U) into position. Attach #3 Roof Panel (U) and #2
Roof Panel (T1) to #3 Roof Supports (O1) by Bolt (BB) and Spacer (X).
□
Slide #4 Roof Panel (T2) into position. Attach #4 Roof Panel (T2) and #3
Roof Panel (U) to #4 Roof Supports (O2) by Bolt (BB) and Spacer (X).
□
Slide #5 Roof Panel (S2) into position. Attach #5 Roof Panel (S2) and
#4 Roof Panel (T2) to #4 Roof Supports (O2) by Bolt (BB) and Spacer (X).
Repeat on each side.
□
Tighten all bolts (BB).
□
Attach #1 Roof Borders (M1) and #2 Roof Borders (M2) to the edge of the
roof as shown witha Bolt (AA). Attach the Short Bar Connector (M4) as
shown with Bolt (AA).
NOTE: Don't tighten the screws rstly untill all roof borders
are installed.
●Assembled by 2 persons.
● Make sure each screw installed on this step is attached to
a Spacer (X).
● Do not tighten the screws until all roof panels nish
installation. If tighten them from the beginning, you will
not be able to install all the roof panels properly.
P2
I1
BB
S1
S1
T1
S2
M2
S1
AA M1
14
Please contact 1-855-HD-HAMPTON for further assistance.
P2
I2
P2 AA
P1
P2
BB
T1
U
T2
S2
BB
X
O1/O2
Note: Don't tighten
U
the screws firstly
untill all roof borders
are installed.
M4
M1
Assembled by 2 persons
HAMPTONBAY.COM
M2
AA