Champlain ACM-180 Instructions

OPEN
1. OPEN
Grip firmly, use pressure and turn
the clear top cover counter-
clockwise to open.
5. REMOTE OPERATION
Point the remote directly at the clear cover
of the light unit. This is important when
the unit is submerged in a swimming pool.
7. Ensure that all threads are
engaged and cover is fully and
evenly sealed on to gasket before
submerging. Failure to properly
seal unit will cause leaks, which
will damage the light and void the
warranty.
2. Remove the battery cover by the
notched tab. Insert 3 AA batteries
(not included). Do not mix old and
new batteries, do not mix alkaline,
standard or rechargeable batteries.
STEEL PLATE
(INCLUDED)
6. This product is for use above ground pool walls with a maximum thickness of 5mm (0.02") or rigid
steel walls. Submerge light no deeper than 25cm (9.8").
DO NOT SUBMERGE THE REMOTE
CONTROL, IT IS NOT WATERPROOF.
3. CLOSE
Match the tab of battery cover to fit on
the back cover. Replace the battery
cover over the LEDs. Replace the clear
cover, turning clockwise until snug. Be
sure the gasket is clean, lubricated
with silicone grease and properly
sealed.
VINYL WALL
1. Contains strong magnets. Keep light away from young children, mobile
phones, magnetic media such as hard drives and other electronic devices.
2. Always make sure the product is thoroughly dry before inserting
batteries.
1. Where freezing temperatures occur, there is danger of damaging the
product. It is recommended to remove, clean, remove the batteries, and
store the product in a safe place when the temperature drops below
42ºF / 6ºC.
2. Thoroughly air-dry all pieces prior to storage.
3. If the product is not going to be used for longer than one month, remove
the batteries, clean them and store light and remote control to prevent
discharge and corrosion.
4. REMOTE CONTROL
Remove the tab to activate the
battery. A #2025 button cell
battery is preinstalled. The remote
can control within 1.2m (47")
distance.
MAXIMUM DEPTH
25cm (9.8")
STEEL WALL
WARNING
STORAGE