Britax Chaperone E9L692J Instructions

Installing the Harness Adjuster
Retention Clip
Lift the cover at the foot of the infant car seat and
1.
confirm that your harness adjuster is attached to the
shell by pulling on the harness adjuster strap.
If the harness adjuster is securely attached go to step
#2. If the harness adjuster is not attached, stop here
and discontinue use of this car seat immediately and
call Britax Customer Service at 1-888-427-4829.
Pull the adjuster strap through the
2.
harness adjuster retention clip as
shown. (See Fig. A)
Angle the harness adjuster retention clip down over the
3.
release button assembly until the top of the clip is seated
under the edge of the shell.
Press down the end of the harness adjuster
4.
retention clip until it latches onto the end of the
infant car seat shell.
Replace the cover and pull the adjuster strap
5.
through the slot in the cover.
This completes the recall remedy.
Pag e 1 of 2
R1 :01. 12
P5 09300
Chaperone™ Infant Car Seat
Instructions / Instrucciones / Instructions
1
2
4
Br ita x Chil d S a fe ty, Inc. , 13501 Sou th Ridg e D riv e, Ch ar lotte, NC 28273, U.S .A
3
5
Con s um er S erv ices : 888.427.4829
© 2012 B rita x Ch ild Sa f ety, I nc. A l l r igh ts r es er ved.
A
www. Br itax. com