TP-Link RE650 User Manual page 7

Chapter 1
1 2 1 LED Explanation
You can check the extender's working status by following the LED Explanation table.
Name
(Signal)
2.4GHz
5GHz
Power
1 2 2 Port and Button Description
Ports or Buttons
WPS Button
Power Button
LED Button
Reset (Hole)
Ethernet Port
Status
The extender is connected to your router's wireless network
Solid blue
and is in a suitable location.
The extender is receiving a weak signal. Try relocating it closer
Solid red
to your router.
Blinking WPS connection is in progress.
Off No wireless connection is established.
The extender is connected to the 2.4GHz wireless network of
On
your router.
Off No 2.4GHz wireless connection.
The extender is connected to the 5GHz wireless network of
On
your router.
Off No 5GHz wireless connection.
On The extender is on.
Blinking The system is starting up or firmware upgrade is in progress.
Off The extender is off.
Press the WPS button on your router, and immediately press the WPS button
on the extender. The
indicating successful WPS connection.
Press the Power button to turn on or off the extender.
Press the LED button to turn on or off all the LEDs.
Use a pin to press and hold the Reset button for 1 second to reset the extender.
Connect your Ethernet-only device to the Ethernet port of the extender to join
the Wi-Fi network.
Get to Know About Your Extender
Indication
Description
LED of the extender should change to solid blue,
4