Operation - YIHUA 853 Series Instruction Manual

IV. Performance Comparison Table
Model
853A
Function
Functional components
Preheating station
Display type
LED
Fahrenheit/Celsius
NO
Conversion
Temperature correction
NO
High temperature protection
YES
Gun Type ---
Control Temperature way Digital PID
Air gun manual /
NO
automatic function
V. Operation
Preheating station part
1. 853A:
A. Preheating station laid out plugged power cord.
B. Move bracket card board, preheat element is placed above the plate, tight-
en the four screws on the bracket, fixed need to preheat components.
C. Turn on the heating switch, the preheat plate heating, set the appropriate
temperature can be preheated.
2. 853AA/853AAA:
A. Preheating station laid out plugged power cord.
B. Move bracket card board, select the appropriate orientation preheat comp-
onents placed above the preheat plate. Note that bracket above three card
board ports, usually use the below one you need to preheat the components
from the hot plate preheat temperature is a little lower.
C. Open the master switch, then open the preheat plate switch set the appro-
priate temperature can be preheated.
D. Preheat station, hot air reworks, soldering station can flexibility combinat-
ion to use. Preheat station, hot air reworks, soldering station three functio-
ns are independent, you can turn off no need part to save energy.
853AA 853AAA
Preheating station
Preheating station
+Hot air reworks+
+Hot air reworks
Soldering station
LED LED
YES YES
YES YES
YES YES
Brushless fan Brushless fan
Digital PID Digital PID
NO YES
15
Hot air reworks part (853AA/853AAA)
1. The hot air gun rework station is laid out handle frame is installed on the side
of the chassis,air gun bracket rack installed in the back of the chassis, fixed to
the handle in the air guns handle frame.
2. Open the back of the chassis whole switch, open air gun switch, air gun begin
heating, press air gun temperature plus button "
" or " to set temperature, adjust the airflow knob to set the appropriate
airflow, gun indicator regularly flashing means the temperature stability will be
able to normal operation.
3. After work, turn off the air gun switch, the machine automatically cut off the air
gun heating body the power to enter the cooling heating element mode. When
the temperature is below 100°C, the air gun display window goes off and stop
the wind.
Soldering station part (853AAA)
1. The soldering iron handle on the iron holder.
2. Open the soldering iron power switch, heating elements begin to heating, pre-
ss soldering iron temperature plus button "
the appropriate temperature, when the soldering iron work indicator regular
flash at high speed into the thermostat state can work properly!
3. After work, you can use the residue under high temperature cleaning sponge
cleaning up the soldering iron tips and re-coated with a new layer of solder,
the soldering iron into the iron hp; der can turn off the power!
Attached:technical article-Rework the process(for reference only)
Air gun with preheating station, to facilitate the large flat IC,dual-panel large compon-
ents de-soldering.
Remove the components:
1. The successful rework first removal location of the fault on mother board, and
the solder is heated to the melting point, and then carefully scored the compo-
nents from the board.
2. Heating control is key factor in the rework, the solder must be fully melted, so
as to avoid injury in the removed component plate and copper. While the tem-
perature is not too high ,to prevent the circuit board is heated excessively cau-
sed motherboard distorted.
or " and minus buttons
" and minus buttons " " to set
16