General Features; Accessories Included; Antenna Location; Installation - Televes CAMPNOVA BOSS User Manual

Hide thumbs Also See for CAMPNOVA BOSS:
Table of Contents

Advertisement

Available languages

Available languages

CAMPNOVA BOSS Antenna
Antenna
designed
especially
integrated with the BOSS-Tech (system signal with
balanced output).
This system makes the antenna automatically
optimize the level of TV signal reception.
It also has a good level of output for optimum
reception, while ensuring low power consumption.
Characterised by its easy installation, robustness
and high electrical performance.
Manufactured
using
materials
resistance to water, wind, etc.

Accessories included

(fig. 1):
1 "Power injector" for battery connection.
1 Cable reel T-100 (14 meters)
3 F type connectors.
1 male IEC type connector.
3 Screws M 5x16
Allen wrench, size 3mm
*
European patent
for
caravans,

General features

10 element Yagui-type antenna (directional),
using Microstrip* technology in UHF, and printed
FM-BIII dipole.
It incorporates our BOSS-Tech shielded amplifier
to manage both VHF and UHF bands; this
technology also allows to pass through these
signals even though the powering is switched-
off.
with
high
System comprising an FM-BIII-UHF antenna,
power injector for voltages between 12...24V
(use with accumulators)

Antenna location

If possible, choose an installation point free from
obstacles, where the antenna can be pointed in the
direction of the transmitter (Fig.2).
Insert the cable through the mast (Fig. 7a).
Place the "F" type connector screwing it over the
cable (Fig. 6).
Insert entire antenna assembly in the tube (make
sure that the connector and the cable are protected
inside the tube).
Place the antenna in the desired orientation and
proceed to lock it definitely tightening the three
screws on the base with an Allen wrench size. 3.
(Fig. 7b).

Installation

Use one of the diagrams shown in figures 8, 9,10 or
11 for installation.
IMPORTANT:
When connect the power injector, make sure that
the polarity of the power cables is correct (red
connected to positive and black to negative), and
also make sure that the antenna is connected to
the output of the injector that provides voltage.
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

144521

Table of Contents