Advertisement
Uni-P EpiFresh 550 AIR MOVERS
Safety Notes
Please note that the EpiFresh 550 should only be used with parts approved by Unipdry. The use of
unauthorized parts or alterations to the machine could void your warranty. Contact an approved
distributor for further assistance.
To Avoid the Risk of Fire or Electric Shock:
Unit must be electrically ground.
Insert 3-prong plug directly into outlet with Ground Fault Circuit Interrupting device.
Do not use an adapter with this unit.
Do not use the unit in standing water.
If electrical parts get wet, they must be dried prior to use.
INTRODUCTION
The Unip EpiFresh 550 is a convenient filtration system that cleans the air. The 550 uses an
effective blend of air flow and advanced filtration to expel airborne particles like mold spores,
dust, pollen, and pet dander. TheEpiFresh is ideal for for restoration jobs, including water,
sewage, and fire.
Identification
Congratulations on purchasing a Unip EplFresh 550 air scrubber. In order to take
advantage of the warranty plan, be sure to note the serial number and date of purchase.
How it works
1. When set to maxiumum airflow, the 550 draws air through two types of filters- a pre-filter
and a HEPA filter.
2. The first phase of filtration, the prefilter, catches the large particles, while the second phase
of filtration, the HEPA filter, catches smaller particles, down to 0.3 microns.
Special Features
Using the auxillary outlet on the control panel, you can link up to 3 units together, creating a
maximum airfow 550 CFM. You can also daisy-chain the machines when they are stacked
vertically (limit of 2 units).
The Unip EpiFresh 550 can be operated in the vertical postion, as well as, when stacked
vertically (up to 2 units). When storing, the machines can be stacked horizontally to
save space.
Tel: 888-990-7469
Installation, Operation & Service Instructions
1
Uni-P EpiFresh 550 AIR MOVERS
Removable Intake Panel
The Unip EpiFresh 550 is equipped with a removable panel on the intake side of the machine. The
removable panel is quite useful in remediation applications, so you can draw air out the room and
create more negative pressure (use a manometer to monitor air pressure). To use panel:
1. Lift latches to remove the panel.
2. Install the machine outside the containment area to draw air out.
3. Cut a hole in the containment plastic that is the size of the units inlet
4. Insert the inlet into plastic and seal the circumference tightly with duct tape.
Key Features
2
Installation, Operation & Service Instructions
Tel: 888-990-7469
Advertisement
