Advertisement
XL2 DISPLAY MODES
Additional modes are accessed by pushing the DOWN button while
powering up the camera. Press M to cycle to the next mode. Cycling camera
power exits these modes and returns to normal operation.
message
System?
English
Camera ?
4 perf
XL2 Ver
116
Cpu
035
Dsp1
005
Dsp2
030
Xilinx
013
Epan
008
Display
012
Magazine
043
Panel
025
meaning
English / Metric unit selection.
Press R and use the [up] or
[down] buttons to select.
4 perf / 3 perf / 2 perf selection.
Press R and use the [up] or
[down] buttons to select.
Camera software version
CPU software version
DSP1 software version
DSP2 software version
Xilinx software version
Epan software version
Display [removable butterfly]
software version
Magazine software version
Control Panel software version
XL2 WARNING MESSAGES
message
meaning and possible solutions
Camera internal temp is below 50°F or 10°C.
Connect 24v battery to camera heater connector. The amber LED
USE HTR
will light up while heater circuit is on.
Battery is 21v or lower. Camera will continue to function, but may
not run correctly at higher than 40FPS.
LOW BATT
Replace weak battery with a fully charged battery.
One of the FTZ motor drivers is damaged, or bad connection at the
connectors. Camera will run normally, but the front face FTZ motor
FTZ BAD
drivers may be disabled.
Contact Panavision
Film jammed in movement. Camera will not run.
FILM JAM
Open the door and clear the jam.
Film magazine is near empty.
FILM LOW
For indication only
Film magazine is empty, and camera stops.
Reload with new film and push "R" button on the Control Panel to
FILM OUT
reset footage counter.
Camera door is open, and camera will not run.
DOOR
Check that door is securely latched.
ILLEGAL
FPS or shutter angle entry is not valid, or outside of specification.
Re-enter the desired speed or shutter value.
SETTING
A behind-the-lens filter is in use.
FILTER
For indication only
Camera is in movement/shutter phase-out mode (i.e. for streaking
PHASE
effect).
OUT
Push "PHASE" button once to get back to normal mode if desired.
Camera is not in phase-out mode.
NORMAL
Push "PHASE" button once to get back to phase-out mode if
desired.
Display blank or
Battery is probably bad.
cycling on/off.
Try a known good battery.
Advertisement
