Hide thumbs Also See for Agava SL 160/28:

Advertisement

MODEL: SL 160/28, SL 170/36, SL 170/28, SL 240/36, SL 240/60
Instructions Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Agava SL 160/28 and is the answer not in the manual?

Questions and answers

Summary of Contents for Soltec Agava SL 160/28

  • Page 1 MODEL: SL 160/28, SL 170/36, SL 170/28, SL 240/36, SL 240/60 Instructions Manual...
  • Page 2 Rev. 03/21 Doc AG-IM-03 www.soltec.si Instructions Manual 2/39...
  • Page 3 We are excited to hand over to you our carefully designed product. Please read the following pages cautiously, in order to use the product properly and safely and to enjoy the quality of it for many years to come. www.soltec.si Instructions Manual 3/39...
  • Page 4 Rev. 03/21 Doc AG-IM-03 www.soltec.si Instructions Manual 4/39...
  • Page 5: Table Of Contents

    ROBLEMS AND SOLUTIONS MAINTENANCE ..........................27 ..........................27 ERVICE RULES ......................29 ISASSEMBLY AND ISPOSAL .................... 30 AINTENANCE AND SERVICE REGISTER WARRANTY ............................32 CERTIFICATE OF PROPER INSTALLATION ................... 35 10 CERTIFICATE OF PROPER INSTALLATION ................... 37 www.soltec.si Instructions Manual 5/39...
  • Page 6 Rev. 03/21 Doc AG-IM-03 www.soltec.si Instructions Manual 6/39...
  • Page 7: Introduction

    EC declaration of conformity (see Chapter2.3). The company Soltec d.o.o. declares that the referenced product was made in accordance with the corresponding EC directives and harmonized standards, in order to avoid possible damages to people, pets or things and to the product itself (for details see Chapter 2).
  • Page 8: Intended Use And Safety Requirements

    Beaufort scale 6 (ca. 50 km/h). The structure can bear even higher loads (60 km/h and more), according to the span of the structure. In cases, where the classified limit is reached, It is advised to open the blades to 45° position. www.soltec.si Instructions Manual 8/39...
  • Page 9 Such cases and any other case of use other than the intended one are to be considered improper and take the responsibility away from the manufacturer, for any damage caused to persons, pets or things. www.soltec.si Instructions Manual 9/39...
  • Page 10: General Information

    2.2 Regulations and self-certification documents The Pergola Agava SL was designed and manufactured in accordance with EU legislation and the applicable EC directives. The EU Declaration of conformity was made according to the harmonized standard EN 13561:2015. www.soltec.si Instructions Manual 10/39...
  • Page 11 The system of assessment and verification of constancy of performance of the product in accordance with EN 13561: System 4 Other conditions applicable: Mandatory use of Instructions manual. Signed for and on behalf of Soltec d.o.o.: Mirko Požar, CEO Dobova, 22.01.2021 www.soltec.si Instructions Manual...
  • Page 12: Ce Marking

    Example of a 160/28 model label affixed to your product, depending on the model: SOLTEC d.o.o., SI 8257 Dobova, Slovenia EN 13561 Intended use: Shade for outdoor use...
  • Page 13: Summary Of Technical Data

    On-site conditions and circumstances may be different than design values of the product. The values must be compatible. The Soltec dealer is in charge of that verification. Water tightness The Structure with the blades in closed position represents a good rain protection.
  • Page 14: Installation

    They have to use appropriate tools and carry appropriate protective equipment. The responsibility of the Soltec retailer is to make sure there is no access to the potential dangerous parts of the motorized structure (blades, motor, wiring, etc.). In case, where these parts could be accessible (height less than 2,5 m, permanent stairs, leaders, etc.,...
  • Page 15: Installation Instructions

    In such cases Soltec cannot be held responsible for any damage which might be arising. Soltec is exempt from any liability in relation to the installation and use of the Pergola regarding the local law and regulations (building permits, concessions, licenses, static rules, safety regulations, etc.).
  • Page 16: Installation Of Electrical Components

    Refer to the installation manual. For any internal motor adjustment, the structure has to be dismounted. www.soltec.si Instructions Manual 16/39...
  • Page 17: Manual For Use

    For an inspection or maintenance of the electrical parts, all electrical parts shall be disconnected from the energy supply in a reliable way. The Bioclimatic Pergola is meant only for intended use. Before use, please read carefully the Chapter 1.3 Intended use and safety requirements. www.soltec.si Instructions Manual 17/39...
  • Page 18 Also, the warranty will terminate immediately. www.soltec.si Instructions Manual 18/39...
  • Page 19: Manual For Operating

    The remote control should be always in good condition and equipped with fresh batteries. PLEASE ASK YOU’RE RESELER FOR THE DETAILED INSTRUCTIONS FOR OPERATING OF THE PERGOLA AND ADITIONAL PARTS. www.soltec.si Instructions Manual 19/39...
  • Page 20: Remote Control - Teleco

    A remote control needs a battery that has already been inserted into it. Please also refer to TELECO manual, available on the manufacturers web page or at this address: https://www.soltec.si/bioclimatic- pergola/documentation www.soltec.si Instructions Manual 20/39...
  • Page 21: Choice Of Channels For Control Of System Components

    (1,2,3,4,5,6,). Channel selection is performed by pressing 1, 2, …,6 the A and B keys Key A: Movement of channels from 6 to 1 Key B: Movement of channels from 1 to 6 www.soltec.si Instructions Manual 21/39...
  • Page 22: Determining The Positions Of The Blades

    F key. Position »½« (90°) Moving the blades to ½ position is done by pressing the E key. Adjustable blades position Moving the blades to any position is done by holding G key or J key. www.soltec.si Instructions Manual 22/39...
  • Page 23: Led Lights

    7 5 % Pressing the D key. 50% illumination strength. Pressing the E key. 5 0 % 25% illumination strength Pressing the F key. 2 5 % Turn off the LED light. Pressing the J key. www.soltec.si Instructions Manual 23/39...
  • Page 24: Zip Roller Blinds

    Move the roller blind up by pressing the D key. Stop the moving roller blind up by pressing the C key. The roller blind stops moving by itself when it reaches the lowest point of the pointer. www.soltec.si Instructions Manual 24/39...
  • Page 25: Heater

    75% heating strength. 7 5 % Pressing the D key. 50% heating strength. Pressing the E key. 5 0 % 25% heating strength. Pressing the F key. 2 5 % Turn off the heater. Pressing the J key. www.soltec.si Instructions Manual 25/39...
  • Page 26: Troubleshooting

    Pergola yourself. Please contact your Soltec dealer. In the case of any failure or damage, contact your Soltec dealer. In case of Mechanical or internal mechanical failure (motor, electronical failure parts, etc.) the pergola has to be dismounted.
  • Page 27: Maintenance

    Before maintenance, be sure to read the whole instructions manual. Make sure, there are no people, pets or things near the Pergola. Only Soltec authorized personnel can intervene with maintenance on the Pergola. If the structure or parts are not maintained according to the Service rules and in case of unsigned maintenance plans the warranty given by the manufacturer, immediately expires.
  • Page 28 (Contact Soltec dealer). Check for any damage due to operating (Contact Every 5 years Soltec dealer). LED lights, heaters, sensors Check for proper function. (Contact Soltec dealer Annually, Refer to separate for instructions) manuals. Side panels, awnings, zip Visual inspection, inspection of movements.
  • Page 29: Disassembly And Disposal

    7.2 Disassembly and Disposal Disassembly of the structure for any reason has to be done only by an professional and authorized Soltec dealer. All instructions, safety measures and warnings given in this instructions manual and installation manual have to be followed.
  • Page 30: Maintenance And Service Register

    Rev. 03/21 Doc AG-IM-03 7.3 Maintenance and service register Authorized Company, Date of Name and signature of Task operation the specialized technician www.soltec.si Instructions Manual 30/39...
  • Page 31 Rev. 03/21 Doc AG-IM-03 The maintenance and service register must be fulfilled according to the Service rules. Every maintenance and service intervention must be recorded for the warranty to be valid! www.soltec.si Instructions Manual 31/39...
  • Page 32: Warranty

    The buyer is aware that there may be discrepancies in the color of the delivered goods compared to the samples shown in the price lists, in the documentation of the company Soltec or in the presentation photographs or materials. Such deviations do not grant the buyer the right to make any claims or the right to cancel the contract or refuse delivery and/or to pay for the products.
  • Page 33 4th year 40% of the value; 5th year 20% of the value. The warranty is limited to the repair or replacement of parts provided by Soltec that have been affected by flaws and/or defects and/or do not comply with the recommended quality.
  • Page 34 The legal remedies of the buyer set out in this document are the sole responsibility of Soltec in connection with any contract or sale or any proceedings performed in connection therewith,...
  • Page 35: Certificate Of Proper Installation

    The undersigned: NAME: _________________________ LAST NAME: _____________________________ ADDRESS:______________________________________________________________________ ______________________________________________________________________________ claims to have purchased the SOLTEC product from the Soltec dealer: COMPANY NAME: _____________________________________________________________ ADDRESS:______________________________________________________________________ ______________________________________________________________________________ VAT: ____________________ TEL.:____________________ E-MAIL: ______________________________...
  • Page 36 To have used only original parts, supplied by Soltec d.o.o. To have handed over to the buyer one copy of the instructions manual, with the manual for use, installation instructions, maintenance instructions and the EC Declaration of Conformity.
  • Page 37: Certificate Of Proper Installation

    The undersigned: NAME: _________________________ LAST NAME: _____________________________ ADDRESS: _____________________________________________________________________ ______________________________________________________________________________ claims to have purchased the SOLTEC product from the Soltec dealer: COMPANY NAME: _____________________________________________________________ ADDRESS: _____________________________________________________________________ ______________________________________________________________________________ VAT: ____________________ TEL.:____________________ E-MAIL: ______________________________...
  • Page 38 To have used only original parts, supplied by Soltec d.o.o. To have handed over to the buyer one copy of the instructions manual, with the manual for use, installation instructions, maintenance instructions and the EC Declaration of Conformity.
  • Page 39 Rev. 03/21 Doc AG-IM-03 www.soltec.si Instructions Manual 39/39...

Table of Contents