Problems Related To Screen - Samsung SyncMaster 510MP User Manual

Check before
calling for service
Installation
Problems and
Solutions
Q & A
1. Problems related to Installation
It appears the PC does not
function normally.
The monitor screen flickers.
TV screen is blurred or shows
noise signals.
TV signal is not received

2. Problems related to Screen

Screen is blank and power
indicator is off
"Check Signal Cable" message
"Not supported Mode" message
Picture rolls vertically.
Image is not clear. Picture is
blurred.
Picture image is unstable and
vibrates.
Ghost images are shown in the
picture.
file://\\soob\03_Manet_Pal\Manual\En\01_htm\06_02.htm
The following table lists possible problems and their solutions. Before calling for service, check the
information in this section to see if you can remedy any problems yourself. If you do need assistance,
please call the phone number on the warranty card,
contact your dealer.
| Screen | Audio | Remote Control
Problems related to the monitor installation and their solutions are listed.
Problems
Problems related to the monitor screen and their solutions are listed.
Problems
the phone number on the Information section or
Solutions
Check if the Display Adapter Driver (VGA Driver) is properly
installed. (Refer to Installing Driver)
Check if the signal cable between the computer and the
monitor is securely connected and tightened.
(Refer to Connecting to a Computer)
Check if the TV antenna connector is securely connected to
the external antenna. (Refer to
Select "Channel auto program" to configure the channel
system automatically. (Refer to the
Solutions
Ensure that the power cord is firmly connected and the LCD
monitor is on. (Refer to the Connecting Your
Ensure that the signal cable is firmly connected to the PC or
video sources. (Refer to the Connecting Your
Ensure that the PC or video sources are turned on.
Check the maximum resolution and the frequency of the
video adaptor.
Compare these values with the data in the
Modes Chart.
Check if the signal cable is securely connected. Connect it
again securely.(Refer to Connecting to a
Run Frequency Coarse and Fine
Turn on again after removing all accessories
(video extension cable, etc.)
Set resolution and frequency to the recommended ranges.
15 inch model (1024 x 768 @ 60Hz), 17 inch model (1280 x
1024 @ 60Hz)
Check if the resolution and frequency set for the computer
video card falls in the range supported by the monitor. If not,
reset them referring to the current
monitor menu and Preset Timing
Connecting to TV)
Auto Store )
Monitor)
Monitor)
Preset Timing
Computer)
tuning.
Information under the
Modes.
10/17/2003