DeDietrich UME 20 User Manual page 9

9- ʺIFEELʺ
key

The reference temperature is on the remote control.

Every 3 minutes, the remote control sends the temperature read by the internal sensor (at the rear of
the remote control).

If there is no response after 10 minutes, the ʺIFEELʺ function is disconnected.

Press this key to validate the ʺIFEELʺ function.

The LCD indicates the actual room temperature.

This function is not active when the appliance is in fan mode.
10- ʺDISPLAYʺ
key.
 In display mode, press the button, switch off the screen and press again. The LCD indicates the room
temperature and the setpoint after flashing for 5 seconds.
11- ʺICLEANʺ
key.
 When the remote control is off, press the "ICLEAN" key. The unit switches to low ventilation speed.
ʺCLʺ appears on the indoor unit and the appliance performs the "iclean" function. The purpose of this
function is to clean any dust from the evaporator and dry up any water inside to prevent unpleasant
odours. To stop the "iclean" function, press the "iclean" button or the "on/off" key. If uninterrupted, the
"iclean" function will stop after 30 minutes.
12- .
The key is not used
13- ʺANTI-FUNGUSʺ

When the remote control is off, press the "ANTI-FUNGUS" key.

After using in cooling mode, dehumidification or ventilation.

The function prevents bacteria and mould from forming to guarantee a healthy environment.

The fan operates for 3 minutes to dry the coil.

The indoor unit emits 5 long beeps and 3 short beeps when this function is activated.

The indoor unit emits 5 long beeps and 5 short beeps when this function is deactivated.
14- ʺ ʺ
key
 Press the key. Automatic switching mode is active.
15- ʺECOʺ
.
key

Press this key in cooling mode. The appliance operates in economy mode.

Up to 35 % saving

After operating for 8 hours, it stops automatically.
16- ʺi Favorʺ
key.

This function allows the appliance to operate under previously saved conditions (operating mode, fan
speed, temperature, shutter position).

Press and hold the "IFavor" key for 3 seconds until the remote control displays the "IFavor" icon,
which flashes 3 times, indicating that the conditions have been saved.

Once the conditions have been recorded, pressing the "IFavor" button saves the conditions.
20180803 CR v3
key.
Page 9