EMS Vigilant-X Series User Manual page 12

Switch the screens on then switch the machine on.
The boot messages should appear on the same screen that they appeared on when the
Vigilant-X master had been installed.
Log on as a user with administrative access rights.
The Found New Hardware Wizard will announce that new hardware has been found. This
will happen once for each slave Vigilant-X card you have added to the system. Do not use
the Found New Hardware Wizard to install the Vigilant-X drivers.
The Windows desktop should appear on the four screens attached to the master card as it did
after the display driver had been installed for the master Vigilant-X card.
You need to install the display driver again. This time you should specify the number of
screens you wish to use.
Restart the machine.
The Windows desktop should now be spread across the number of screens you specified.
If you encountered any problems, please refer to the Troubleshooting section.
Connecting the HDTV-S-Cable
The HDTV-S-Cable enables the outputs from the Vantage card to be displayed on HDTV and
standard TV.
12
16/03/2006