Table of Contents
Advertisement
Use oil-free cotton cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change
the cloth and wipe several times if it is not clean enough.
Warning
This camera should be installed by qualified personnel only.
•
All the examination and repair work should be done by qualified personnel.
•
Any unauthorized changes or modifications could void the warranty.
•
As a security measure, for installations not on a plug and play NVR, make sure to modify the default password
•
after login.
Do not use more than one power source for the device.
•
Statement
This guide is for reference only.
Product, manuals and specifications may be modified without prior notice. Speco Technologies reserves the right to
modify these without notice and without incurring any obligation.
Speco Technologies is not liable for any loss caused by improper operation.
FCC Information
1. FCC conditions:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference
•
This device must accept any interference received, including interference that may cause undesired operation.
•
2. FCC compliance:
This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference. This equipment
generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
Note
Before installation, check the package and make sure that all components are included.
Contact your rep or Speco customer service department immediately if something is broken or missing in the
package.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
ii
Advertisement
Table of Contents
