Advertisement
SAMPLE
CLEAN FILTER
CLEAN FILTER
This oven displays
message displays ACP recommends
off the message. The message will
stop displaying automatically after
24 hours. Depending on microwave
use and environmental conditions,
more frequently. Once the frequency
is determined, set the option for the
appropriate time frame.
Preprogrammed
Pads
To cook food using
preprogrammed cooking
sequences.
1. Open oven door and place food
in oven. Close door.
‡ To add additional servings
press QUANTITY pad.
‡ Up to eight quantities can be
added.
2. Press desired pad.
3. Oven begins to cook.
4. At end of cooking cycle oven
beeps and shuts off.
displays.
Mid-Cycle Pause
To add a pause to a programmed
cooking cycle:
1. Press HIDDEN PAD after
entering time or power level.
2. A short beep sounds. This
indicates the program is set for a
mid-cycle pause.
3. Continue programming pad as
desired.
When programmed pad is used,
pause will occur in the middle of total
programmed time. Oven will beep
continuously and Program Paused
displays until door is open and shut.
To continue cycle, press START pad.
Quick Start Reference Guide
Refer to Product Safety Manual for Safety Statements
Quantity Time Entry Power Level Stage Program Save
Manual Operation
1. Open oven door and place food in oven. Close door.
2. Press TIME ENTRY pad and enter cooking time.
3. Press POWER LEVEL pad to change power level if desired.
‡ For a lower microwave power, press pads 1 (for 10%) through 9 (for
90%).
4. If stage cooking is desired, press STAGE pad and repeat steps 2 through 4.
5. Press START pad.
6. At end of cooking cycle oven beeps and shuts off.
Programming Pads
1. READY must be in the display. If not, open and close door.
2. Press PROGRAM SAVE pad.
DONE
‡ Programming mode begins.
‡ Enter Program to Add/Review: displays.
3. Press pad to be programmed or reprogrammed.
‡ Display will change to review all settings for the pad.
‡ The pad number that is being programmed displays beside the word
ITEM.
4. Press TIME ENTRY to program amount of cooking time.
‡ Enter desired cooking time by using numeric key pads.
‡ Maximum cooking time is 60 minutes.
5. Press POWER LEVEL to program level of microwave power.
‡ Press numeric key pad for desired level. Press numeric key pad again
to set power level to 100%.
‡ For a lower microwave power, press pads 1 (for 10%) through 9 (for
90%).
6. Press Quantity pad if different cooking factor is desired.
‡ Default of CF:80 displays.
‡ Enter desired cooking factor by using numeric key pads (1 for 10%
through 0 for 100%).
7. Press PROGRAM SAVE to save the program changes.
8. To discard changes, press STOP/RESET.
Complete Owner's Manual available online
Oven Clearances
A—For North American (UL/CSA) models, allow at
least 2" (5.1 cm) of clearance around top of oven.
For International (50 Hz) models, allow at least 7"
(17.8 cm) of clearance around top of oven. Proper air
life of electrical parts is reduced.
B—Allow at least 2
discharge on back of oven and back wall.
C—Allow at least 2" (5.1 cm) around sides of oven.
So...how do I use it?
11
9
/
" (6.5 cm) between air
16
DONE
displays.
Advertisement
