Lanpro LP-SG2402FP3 Series Manual

1 2 3 manual power supply voltage range change from 100-120vac to 200-240 vac

Active Products - Switches

LP-SG2402FP3x

1 2 3 Manual for Power Supply Voltage range change

from 100-120VAC to 200-240 VAC

LPSG2402FP3x_M123_ENB01W

LP-SG2402FP3x

1 2 3 Manual for Power Supply Voltage

range change from 100-120VAC

to 200-240 VAC

The LP-SG2402FP3x is a 24 x 10/100 Mbps 802.3af PoE Ports Switch

without Management + 2 x 10/100/1000 Mbps Dual Uplink Copper or SFP

Ports that has a two Input Voltage range power supply.

It comes standard with the 100-120 VAC voltage range unless it was

ordered from the factory with the desired range. In this case, it must be

changed to the 200 to 240 VAC range, when the local mains power voltage

is between 200 and 240 VAC.

In order to change the standard range to the 200 to 240 VAC range,

please follow the next steps.

Opening the chassis

In order to make the range change, the "Warranty Void if Broken" label

must be broken to access the screw under it. This will void your warranty

unless you ask your preferred LanPro Inc. local representative to make

this change for you for a nominal charge and replace the warranty label.

www.lanpro.com

Table of Contents

Do you have a question about the LP-SG2402FP3 Series and is the answer not in the manual?

Page 1 In order to make the range change, the “Warranty Void if Broken” label must be broken to access the screw under it. This will void your warranty unless you ask your preferred LanPro Inc. local representative to make this change for you for a nominal charge and replace the warranty label.
Page 2 1 2 3 Manual for Power Supply Voltage range change from 100-120VAC to 200-240 VAC In order to open the Power Supply Chassis, please unscrew three front top screws, 6 lateral and 4 back screws. Please refer to Figure 1. Figure 1 www.lanpro.com...
Page 3 230 V Range value appears in the window as shown in Figure 3. Figure 3 Changing the Input voltage range label to reflect the new range Please peel off the backing of the replacement new range label and align and adhere over the old label as shown in Figure 4. www.lanpro.com...
Page 4 1 2 3 Manual for Power Supply Voltage range change from 100-120VAC to 200-240 VAC Figure 4 Closing the switch chassis Now we can close the chassis again, first by aligning the cover. Please refer to Figure 5. Figure 5 www.lanpro.com...
Page 5 Please see Figure 6. Figure 6 LanPro is continuously improving its products and reserves the right to change specifications and availability without prior notice. www.lanpro.com...