Advertisement
ALTERING THE TEMPERATURE (REFRIGERATORS
WITH ANALOGUE/DIAL THERMOSTATS)
YOUR REFRIGERATOR IS FITTED WITH AN
ANALOGUE/DIAL THERMOSTAT WHICH RANGES
FROM 0 TO 6. 0 IS OFF, 1 IS WARMEST THROUGH
TO 6 THE COLDEST SETTING.
EFFICIENCY
AND
REFRIGERATOR IS FACTORY PRESET BETWEEN
POSITION 4-5, TO DECREASE THE TEMPERATURE
INSIDE THE REFRIGERATOR TURN THE THERMOSTAT
TO RIGHT (INCREASE THE NUMBER).
3
4
2
5
1
6
0/OFF
ADJUSTING THE SHELVES
THIS REFRIGERATOR IS FITTED WITH ADJUSTABLE
SHELVES WHICH CAN BE MOVED TO SUIT
DIFFERENT SIZE PRODUCTS.
SHELVES REMOVE THE SHELF COMPLETELY FROM
THE UNIT TO REVEAL THE SHELF CLIPS. LIGHTLY
SQUEEZE THE CLIPS TOGETHER BY HAND AND
LIFT THEM UPWARDS TO REMOVE THEM FROM
THE SUPPORT LADDER.
IMPORTANT: DO NOT USE PLIERS OR TOOLS
TO SQUEEZE THE SHELF CLIPS TOGETHER AS
THIS WILL DEFORM THEM AND THEY WILL NO
LONGER SUPPORT THE WEIGHT OF THE SHELF.
TO REINSTALL THE CLIPS INTO THE CORRECT
LOCATION PLACE THE BOTTOM LUG OF THE CLIP
INTO THE SUPPORT LADDER, SQUEEZE TOGETHER
BY HAND AND INSERT THE TOP LUG INTO THE
LADDER SUPPORT.
FOR OPTIMUM
PERFORMANCE
YOUR
TO ADJUST THE
DEFROSTING
THIS
REFRIGERATOR
AUTOMATIC DEFROST SYSTEM.
DEFROSTING IS NOT REQUIRED UNDER NORMAL
CIRCUMSTANCES.
IN HUMID CONDITIONS MOISTURE IN THE AIR
MAY CAUSE AN EXCESS BUILD UP ON FROST ON
THE INSIDE OF THE UNIT.
ELITECH CONTROLLERS: A MANUAL DEFROST
MAY BE STARTED (IF TEMPERATURE CONDITIONS
ARE CORRECT) BY PRESSING AND HOLDING THE
DEFROST BUTTON
MANUAL THERMOSTAT MODELS: UNLOAD THE
CABINET AND TURN OFF UNTIL ALL FROST AND
ICE BUILD UP HAS NATURALLY MELTED. A TOWEL
MAY NEED TO BE PLACED UNDER THE CABINET
TO SOAK UP ANY EXCESS MOISTURE GENERATED
DURING DEFROST. IF FROST BUILD UP REOCCURS
AND THE CABINET IS WITHIN ITS NORMAL AMBIENT
OPERATING TEMPERATURE THE THERMOSTAT MAY
BE SET TOO HIGH, REDUCE THE NUMBER THAT THE
THERMOSTAT IS SET TO.
WARNING
NEVER REMOVE FROST OR ICE BUILD UP WITH
A SHARP IMPLEMENT OR TOOL AS THIS WILL
DAMAGE THE REFRIGERATION SYSTEM AND
WILL VOID YOUR WARRANTY
WARNING
NEVER TOUCH THE EVAPORATOR SURFACE
WHEN THE MACHINE IS RUNNING AS THIS MAY
CAUSE INJURY TO THE USER
LOADING YOUR CABINET
ALLOW YOUR CABINET TO RUN FOR 2 HOURS
AFTER
INSTALLATION
PRODUCTS INTO THE REFRIGERATOR.
ALWAYS LOAD YOUR REFRIGERATOR IN BATCHES,
FULLY LOADING YOUR CABINET WITH WARM
PRODUCT
WILL
TEMPERATURE AND MAY CAUSE LOSS OF
PRODUCT.
5
PART III
IS
FITTED WITH
MANUALLY
FOR 3 SECONDS.
BEFORE
LOADING
INCREASE
THE
CABINET
XD080818UM Rev 1.3
AN
Advertisement
