NKT Koheras BOOSTIK User Manual page 4

Koheras BOOSTIK
User Guide
Custom stand-alone installation
For simple custom systems, the amplifier module must be placed on a
level and stable surface. The module can be bolted for example, to a
table using a custom mounting bracket (not included) attached to the
side of the module.
Note:
Follow these installation rules:
•
Allow for proper ventilation and cable access.
• Do not store or place anything on the top panel of the amplifier.
• Ensure the ambient operating temperature and humidity is
stable as stated in the
the amplifier near sources that could cause temperature
fluctuations.
• The surface the amplifier is placed on, must be free of vibration
or mechanical shocks.
Cooling
The amplifier module generates substantial heat during operation. For
proper operation, you must ensure that the heat is dissipated by
providing an efficient thermal path from either the rear panel or the
side panel as illustrated. (Cooling blocks or heat sinks are not included.)
Connect the module to a CONTROL PC
The amplifier module is designed as a component in a laser system that includes safety and communication
functionality. The module can be operated using NKT Photonics CONTROL application installed on a PC. To
establish communication between a CONTROL PC and the amplifier, first make the following connections to the
appropriate main electrical interface:
12 VDC power and ground
•
A door switch safety interlock circuit that complies with applicable safety regulations.
•
An RS-485 data connection between a PC and the amplifier.
•
Optional RS-485 adapter kit
For system integration and testing, the amplifier module can be provided with an
optional kit that provides the necessary power, interlock and communications to
operate a stand-alone module. To use the kit, follow the steps below and refer to
the adapter description "RS-485 Adapter" on page
a. Connect the BOOSTIK interface board to the main interface 30 pin C/3
connector on the rear panel of the module.
b. Using the IDC 16 pin to DB-15 ribbon cable, connect the NKT Photonics RS-485
adapter to the 16 pin main interface connector on the BASIK interface board.
c. Connect the RS-485 adapter to your PC using the USB-A to USB-B cable.
d. Connect a door safety switch circuit using the two-pin LEMO connector to the
interlock port of the RS-485 connector.
e. To power on the module, connect the power supply to the RS-485 adapter
power jack and AC mains.
Warning:
When using the adapter kit, DO NOT CONNECT a laser seed source and ONLY use the adapter kit for
temporary test purposes. Connecting the BOOSTIK to a laser seed source along with an RS-485 adapter is UNSAFE
and contravenes IEC standard 60825-1 Safety of Laser Products.
"
Amplifier Specifications". Avoid placing
8:
M6 x M6 x bolt
？bolt
M6 x ？bolt M6 x
Cooling block
attached to
side panel
Interlock
USB to PC
12 VDC input
4
bolt
BOOSTIK interface board
Ribbon cable