Technical Data - MC Crypt BS-3050 Operating Instructions Manual

• Lay the loudspeaker cables to the support as shown in the above illustrations.
• Connect the loudspeaker cables from the amplifier to the terminal strip on the loudspeaker:
positive loudspeaker cable >
negative loudspeaker cable >
• Turn the rotary switch below the terminal strip into the required position.
Connection to a hi-fi amplifier:
Turn the rotary switch of the loudspeaker to the position: 8 Ohm.
Connection to an ELA amplifier:
Turn the rotary switch into one of the positions: 3.75 / 7.5 / 15 / 30W.
The output rating and therefore, the volume of the loudspeaker, is controlled by the position
of the rotary switch on the loudspeaker.
The higher the output value set the louder the loudspeaker is compared to the other loud-
speakers connected.
In no case turn the rotary switch to the position 5 (8 Ohm) when connecting
the loudspeaker to an ELA amplifier.
• Fasten the ELA wall loudspeaker(s) to the bracket as indicated.
• If you wish to remove the ELA wall loudspeaker from the support again, proceed as follows:
Connection (+) or red
Connection (-) or black
-
Maintenance and Care
The ELA wall loudspeaker is maintenance-free.
Clean the exterior of the device only with a dry cloth. Make sure not to damage the sensitive
speaker membranes.
Never use aggressive cleaning agents or chemical solutions as the housing's surfaces or the
membrane could be damaged.
Disposal
Please dispose of the product, when it is no longer of use, according to the current
statutory requirements.

Technical Data

Woofer
Tweeter
Impedance in hi-fi mode
Load capacity in hi-fi mode (RMS/max.)
Input voltage range for ELA operation
Output stages ELA operation
Frequency range
Sound pressure
Dimensions
Ground
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2009 by Conrad Electronic SE.
130mm
25mm Mylar-Dome
8Ohm
30/45W
100/70V
3,75/7.5/15/30W
110 – 20,000Hz
90+/-3dB
230 x 310 x 175mm
2.2kg