GE AvantaPure Professional Series Operation Manual page 38

38
Rev H
NOTE: Regeneration on specific day is used to provide regeneration
when water demands are not steady. Example: If the weekdays have
low usage and the weekend is high, then regeneration every three days
will not meet the requirements.
The calendar override days between regeneration must be set to zero
to enable regeneration on specific days.
The 263 filter controller can be programmed to regenerate on an elapsed
time period (calendar override) or by the day of the week. If you would like
to regenerate on specific days select a 0 (zero) for the calendar override
setting, the 263 filter will prompt you to select the days of the week in
which you would like the unit to regenerate/backwash. For example, the
unit could be programmed to regenerate every Monday, Wednesday and
Friday.
Viewing the Salt Amount (268 softener only)
Is selected by the system model number (see Table 1). The table listed
below is for reference only. Your AvantaPure Water Treatment Professional
enters the model numbers based on the specific application requirements.