Connecting The Video Out To Your Tv - Samsung HT-TXQ120 Instruction Manual

Connecting the Optional Wireless Receiving Amplifier
Resetting the Wireless Receiving Module
Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver does not
light up and the "REAR CHECK" message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module (SWA-3000) are in Power Standby mode.
• When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker Output
Connector on the back of the subwoofer.
• The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and
moisture.
• For optimal listening performance, make sure that the area around the wireless receiver module location is clear of
any obstructions.
• Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.
• In 2-CH mode, no sound will be heard from the wireless rear speakers.
• Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close
to the main unit, some sound interruption may be heard due to interference.
• If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that
uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.
• The transmission distance of a radio wave is about 10m, but may vary depending on your operating environment.
If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system may
not operate at all, because the radio wave cannot penetrate metal.
18
1
With the main unit turned off, press and hold the remote
control's REMAIN button for 5 seconds.
The STANDBY LED on the front panel of the wireless receiver module
blinks.
2
With the wireless receiver module turned on, use a ball point
pen or a toothpick to press the RESET button on the back of
the unit.
The STANDBY LED on the front panel of the wireless receiver module
blinks 2 Times.
3
Turn on the main unit.
The LINK LED of the wireless receiver module is lit and the Reset is
completed.
If Power Standby mode continues, repeat Steps 1 to 3 above.

Connecting the Video Out to your TV

(Con't)
Choose one of the three methods for connecting to a TV.
Rear of
Subwoofer
METHOD 1 : HDMI ....... (Best Quality)
Connect the supplied HDMI cable from the HDMI OUT jack on the back of the Main Unit to the HDMI IN jack on your TV.
METHOD 2 : Component ....... (Better Quality)
If your television is equipped with Component Video inputs, connect a component video cable(not supplied) from the
Component Video Output (PR, PB and Y) Connectors on the back of the subwoofer to the Component Video Input
Connectors on your TV.
METHOD 3 : Composite Video ....... (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back of the subwoofer to the VIDEO IN jack on your
TV.
• This product operates in Interlace scan mode (576i, 480i) for component output.
TV
METHOD2 METHOD 3 METHOD 1
(supplied)
(supplied)
GB
Rear of
Main unit
19