Assembly Instructions; Inserting/Replacing The Brush; Mounting The Guiding Roller; Mounting The Additional Handle - Grizzly ERB 550-3U Translation Of The Original Instructions For Use

Vibration (a )
h
additional
handle .............. 3,542 m/s
handle .............. 2,421 m/s
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration
of conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another. The stated
vibration emission value may also be used
for a preliminary exposure assessment.
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched off
and times when it is switched on but
running without any load).
Assembly
instructions
The brush support (15), the hexa-
gon socket wrench (16) and the
metal brush (17) are situated in the
two compartments in the additional
handle (13).

Inserting/replacing the brush

; K= 1,5 m/s
2 2
; K= 1,5 m/s
2 2
Release/fasten the fixing screw on the
inside of the nylon brush (10/18) on the
motor head (12) using the hexagon socket
wrench (16).
1. Push open the brush support (15)
2. Insert the desired brush.
3. To remove the brush, push the brush

Mounting the guiding roller

Mounting the additional handle

1
Nylon brush (10/18):
2
Metal brush (17):
and attach it as it is to the motor head
(12) (see A ). Release the brush sup-
port (15) and it will spring back into its
initial position.
support (15) open and remove the
brush (see B ).
1. Insert the guiding roller (11) on to
3
the motor head (12). It locks into
place audibly.
- If using the nylon brush
(10/18), place the guiding roller
(11) into the transport position
(20).
- If using the metalbrush (17),
place the guiding roller (11) into
the working position (18).
2. Release the guiding roller (11) by
pushing the retaining tab (19) and
remove the guiding roller (11).
1. Unscrew the additional handle
4
(13) to take apart.
2. Insert the additional handle (13)
into the holder beneath the han-
dle (1).
GB
23