Magnetek SBP2 Manual

Magnetek SBP2 Manual

Pendant pushbutton stations
Hide thumbs Also See for SBP2:

Advertisement

Quick Links

®
SBP2
Pendant Pushbutton
Stations Installation Instructions
P.O. Box 13615
Milwaukee, WI 53213-3615
Distributed by Ergonomic Partners
Sales@ErgonomicPartners.com
www.ErgonomicPartners.com
Tel: (314) 884-8884
Part Number: 005-1053 R5
©2014 Magnetek

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SBP2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Magnetek SBP2

  • Page 1 ® SBP2 Pendant Pushbutton Stations Installation Instructions P.O. Box 13615 Milwaukee, WI 53213-3615 Distributed by Ergonomic Partners Sales@ErgonomicPartners.com www.ErgonomicPartners.com Tel: (314) 884-8884 Part Number: 005-1053 R5 ©2014 Magnetek...
  • Page 2 Magnetek. consult Electromotive Systems at 1-800-288-8178. DISCLAIMER OF WARRANTY Read the entire contents of this manual before you install or use the SBP2 Pendant Pushbutton Station. Magnetek, hereafter referred to as Company, assumes no responsibility for improper use of supplied product by untrained personnel. Product should only be installed or repaired by a trained technician who has read and understands the contents of this manual.
  • Page 3 ® Replacement Parts Installing and Wiring SBP2 Pendant Pushbutton Station Description Catalog # Precautions at Installation Single Speed 2-Button Switch SBP2-A2  Do not expose the unit to cold blasts of air that might cause Single Speed 2-Button Switch (N.O./N.C. per button) SBP2-AB2 condensation (e.g., air conditioning duct).
  • Page 4 6-Button- All Two-Speed SBP2-6-WS 6-Button- All Three-Speed SBP2-6-WT NOTE: Magnetek recommends the use of a suitable outdoor rated and 8-Button-(6) Single-Speed with On/Off SBP2-8-WB oil resistant pendant cable that is both UL Listed and CSA recognized. 8-Button-(6) Two-Speed with On/Off...
  • Page 5 Wiring and Marking Information Enclosure Reassembly WARNING When tightening enclosure screws, do not exceed 9 inch pounds of torque. Overtorquing enclosure screws may cause damage to the enclosure. 1. Ensure that there are no bare cable conductor strands and that all conductors are insulated from each other.
  • Page 6 Do not attempt to turn knobs or switches beyond their travel limits. CAUTION Do not operate equipment and/or pendant without switch gasket and label. Damaged switch gaskets and labels should be replaced to prevent contamination of the switch contacts. Call Magnetek at 800-288-8178 for replacement gaskets and labels.
  • Page 7  When cutting or stripping wires, ensure that particles do not fall into the enclosure. Operating SBP2 Pendant Pushbutton Station Safely When using a pendant station, take the following precautions: Maintenance  On a continual basis, ensure that the interlock mechanism is...
  • Page 8 Typical Installation of Strain Relief Round Cable Distributed by Ergonomic Partners Sales@ErgonomicPartners.com www.ErgonomicPartners.com Tel: (314) 884-8884...

Table of Contents