Table of Contents
Advertisement
•
Always read and follow the chemical label instructions exactly. Understand safe practices for chemical handling,
mixing, loading, cleaning, and first aid.
•
Always wear proper Personal Protective Equipment when handling chemicals, including gloves, eye protection,
respirator and safety shoes.
•
Always pay attention to wind conditions when using the Cleanload. DO NOT use Cleanload in wind in excess of
10MPH due to possibility of tipping.
•
Always check to make sure that there are no loose objects surrounding the Cleanload that could cause damage to
the hopper tank or hoses.
•
When operating the Cleanload at night, ensure proper lighting (200 to 300 Lux) is present.
•
IMMEDIATELY SHUT DOWN the system if leaks, errant spray, operation error, or malfunction occur.
Before Operation
•
Inspect the assembly for signs of leaks.
•
Ensure all hoses or fittings are properly attached to the Cleanload.
•
Ensure hopper valve (red handle) and Cyclo rinse valve (blue handle) are in the closed position and that the bypass
valve (yellow handle) is in the open position.
•
Ensure proper pump /system sizing for proper eductor function prior to using chemicals. Trial with water is
recommended to ensure safe operation. Proper function is indicated by water being drawn into the line, and not
backing up inside the hopper.
•
If water backs up in hopper when the pump is on, ensure the hopper valve (red handle) is open to allow flow from the
enclosure. If the backup persists, immediately close the Cyclo Rinse (blue handle) and the hopper valve (red handle)
and shut off the pump. Review outlet plumbing to minimize restrictions or blockages.
Start-up, Operation, Shut Down
1. Turn on the pump to generate clean water flow.
2. Open the tank hopper (red handle) and the Cyclo Rinse valve (blue handle), close the bypass valve (yellow handle)
3. Inspect assembly for leaks.
4. Open the chemical container, pour and measure the chemical. Pour the measured chemical into hopper.
5. Triple rinse the measurement container using bottle rinse inside hopper
6. If more than one container is needed repeat steps 4 & 5.
7. Rinse chemical container(s) to ensure any chemicals on the exterior are removed.
8. If container(s) are empty, triple rinse the container(s) using bottle rinse inside hopper.
9. Close the Cyclo rinse valve (blue handle) and wait for 15 seconds. Close the hopper valve (red handle).
10. If more chemicals need to be added to the tank repeat steps 1-11.
11. Open the bypass valve (yellow handle) and continue to transfer water as needed or shut off pump.
ATTENTION: Divert or stop all flow to and from the Cleanload system before performing any service or maintenance
procedures.
ATTENTION: Always wear proper Personal Protective Equipment when handling chemicals including gloves, eye
protection, respirator and safety shoes.
ATTENTION: Always dispose of chemicals and contaminated water in accordance with national and local laws and
statutes.
Start-up, Operation, Shutdown
Maintenance and Servicing
Information
- 8 -
Advertisement
Table of Contents
