Table of Contents
Advertisement
Quick Links
WWW.SMITTYBILT.COM
SPECIFICATIONS:
Motor: 12-Volt DC
Maximum working pressure: 120psi.
Maximum re-start pressure: 90psi.
Maximum continuous operating time is 40 minutes.
Recommended on/off cycle time: 20/40 minutes
Overheating Protection Circuit:
The unit is equipped with an automatic protection device. In the event the unit reaches an unsafe operating
temperature, a protection circuit will cut power to prevent damage to the unit. If the protection circuit
activates, immediately disconnect the unit from the power source and allow it to cool.
The unit will cool in approximately 15 minutes, depending on environmental conditions. The protection
circuit will automatically reset itself when the temperature returns to a safe operating level.
High altitude and certain air temperatures can negatively affect the unit's performance.
WARNINGS:
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
For Technical Support/Warranty Information please call 310-762-9944
READ ALL INSTRUCTIONS before operating product. Failure to follow all
instructions below may result in electrical shock, fire and serious injury or death.
Always wear ANSI Z87.1 approved safety glasses with side shields when operating.
Compressed air and particulate matter can cause eye and soft tissue damage. Keep air
stream away from skin and eyes.
RISK OF BURNS: Always wear gloves. Some exposed parts may become hot during
use.
RISK TO BREATHING: This compressor is not designed for and never should be
used as a source of breathable air.
RISK OF ELECTRICAL SHOCK: This compressor is for use in dry conditions
only.
RISK OF FALLING: This compressor will produce vibrations and can "walk." Only
operate at ground level.
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
(Part # Q89)
Dual Cylinder Air Compressor
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Smittybilt Q89
Summary of Contents for Smittybilt Q89
- Page 1 RISK OF ELECTRICAL SHOCK: This compressor is for use in dry conditions only. WARNING! RISK OF FALLING: This compressor will produce vibrations and can “walk.” Only operate at ground level. For Technical Support/Warranty Information please call 310-762-9944 Smittybilt, 400 West Artesia Blvd, Compton, CA 90220...
- Page 2 This unit is designed to supply continuous flow of air. Never dead end the hose or use accessory that stop the free flow of air. Damage to the unit can occur. For Technical Support/Warranty Information please call 310-762-9944 Smittybilt, 400 West Artesia Blvd, Compton, CA 90220...
- Page 3 If you stop the unit and need to resume inflation, remove the inflator tip from the tire valve, start the unit and reattach with the unit running. For Technical Support/Warranty Information please call 310-762-9944 Smittybilt, 400 West Artesia Blvd, Compton, CA 90220...
- Page 4 Push back and turn the brass end to deflate. 2. Inspect inside the ez twist inflator for damage to the O rings. If they are damaged contact Smittybilt for a replacement hose. For Technical Support/Warranty Information please call 310-762-9944 Smittybilt, 400 West Artesia Blvd, Compton, CA 90220...
- Page 5 Customer’s remedy hereunder shall be limited only to repair or replacement (at Smittybilt’s option) of any defective part(s) returned to Smittybilt at customer’s expense. The determination of whether or not a returned part is defective or subject to coverage under the limited warranties stated herein shall be made at Smittybilt’s sole discretion.
Need help?
Do you have a question about the Q89 and is the answer not in the manual?
Questions and answers