Advertisement
Quick Links
Assemly tutorial: CALUCORE-M
The following components are on the desk:
-
CALUCORE-M barebone
-
AC power adapter + power cable
-
Screws (for HDD, CD-ROM adapter, CD-ROM, CPU cooler) + heat sink compound + EMI stickers
-
Quick installation guide and a motherboard driver CD
We are using these components in our tutorial:
-
Slimline CD/DVD drive
-
40 GB SATA HDD
-
1024 MB SO-DDR2 RAM
-
T2300 Core Duo CPU
The enclosure gets opened and the motherboard gets pulled out:
Advertisement
Related Manuals for Cartft CALUCORE-M
Summary of Contents for Cartft CALUCORE-M
- Page 1 Assemly tutorial: CALUCORE-M The following components are on the desk: CALUCORE-M barebone AC power adapter + power cable Screws (for HDD, CD-ROM adapter, CD-ROM, CPU cooler) + heat sink compound + EMI stickers Quick installation guide and a motherboard driver CD...
- Page 2 Now the motherboard is lying in front of us and we can begin with the installation of the SO-DDR2 RAM: The mounting unit for the CD/DVD drive gets removed:...
- Page 3 The SATA HDD gets plugged into its correct place: On the rear of the motherboard you can fasten the SATA HDD with 4 screws:...
- Page 4 Installing the CPU: The CPU gets installed into the Socket, which is shown at the lower right in the picture: Then you take the CPU and check the arrangement of the pins, so that the CPU sinks into the socket without any reluctance and effort.
- Page 5 Then install the CPU Cooler carefully, so that all screw threads are matching through the scheduled screwing hole. The best thing is to screw the CPU cooler screws cross-over, so that the CPU doesn’t get damaged with too much pressure on one side.
- Page 6 After that the CD/DVD drive can be connected to the slimline adapter and it can be screwed with the long screws of the adapter: Tighten the CD/DVD drive on both sides:...
- Page 7 The EMI Stickers get posted onto the surface of the CD/DVD drive: It should look like this, before you are going to push it into the enclosure again:...
- Page 8 Falls eine kleine Plastikblende am Gehäuse ist, wird diese noch vorher entfernt: The motherboard can be pushed into the enclosure:...
- Page 9 Finally the motherboard gets screwed at the enclosure. Finished – The CALUCORE-M is assembled.
- Page 10 Autor: B. Lambert - CarTFT.com Letzter Stand: 12.06.2007...