Alpha Technologies Cordex CXC Series Removal Procedure

Language file removal

Advertisement

Quick Links

Cordex Controller Language File Removal Procedure

Disclaimer:

This process enters the flash file system on the CXC controller and provide access that allows for
very damaging result if manipulated without due care. Please follow the instructions to remove the
third language file carefully. Any other activity is outside the scope of this procedure and will not be
supported.

Background:

There are two default language files in the CXC software, English and Chinese. A third language file,
when inserted, will be saved on the flash as CXCTEXTLANG_3. This file can be accessed through a
NULL modem serial connection and deleted manually if the third language needs to be removed.

Tools/Information Required:

• Laptop
• Null Modem Cable

Procedure:

( please read through all steps first to get familiar before starting the activity )
1. Connect a null modem cable from the CXC to your computer using a DB9 connector.
2. Open any standard terminal program and set the communication parameters to 57.6kb/s, 8 data
bit, No parity, 1 stop bit, No flow control. Example below:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Cordex CXC Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Alpha Technologies Cordex CXC Series

  • Page 1 Cordex Controller Language File Removal Procedure Disclaimer: This process enters the flash file system on the CXC controller and provide access that allows for very damaging result if manipulated without due care. Please follow the instructions to remove the third language file carefully. Any other activity is outside the scope of this procedure and will not be supported.
  • Page 2 *COM port may be different.
  • Page 3 3. Reset the CXC controller and at startup you will see the startup messages. 4. At this point, press Ctrl-C. If you pass this point without pressing Ctrl-C, normal startup will continue and you must reset the CXC again. If stopped successfully, you will see a command prompt.
  • Page 4 The number at the end of the name should be 3. 6. To remove the file, enter the following command: tfs rm CXCTEXTLANG_3 This will delete the file and you can confirm with tfs ls. 7. Type reset to restart the CXC. Thank you for choosing Alpha Technologies...

Table of Contents