Advertisement
Quick Links
Advertisement
Related Manuals for Gemas PURITRON GSC 10
Summary of Contents for Gemas PURITRON GSC 10
- Page 1 INSTRUCTION MANUAL GEMAS pH CONTROLLED PURITRON 1. Introduction SALT WATER CHLORINATOR 2. Salt Water Chlorinator Description 3. Installation 4. Water Preparation 5. Salt Addition 6. Operating 7. Recommendations 8. Technical Characteristics 9. Warranty, After-Sales Service and Spare Parts...
- Page 2 Any damage caused to the chlorinator resulting from unapproved executions except for the warnings may lead to out of warranty cover. 1- Introduction 2- Salt Water Chlorinator Description We thankfull for your trust in us with your purchase of a GEMAŞ You will find the following elements in your GSC Device package: Puritron Salt-Water Chlorinator.
-
Page 3: Installation
4 pieces 8 dowel and 4 pieces 5x40 wood screw 1 piece pH dosage pump electrical output socket O’ring seal Dosage pump Wall Bracket PH Probe electrical socket 3- Installation 220 V electrical Cell housing (4) connection pH electrode The cell housing(4) will be installed in the return flow to the swimming pool and will be always after connection connection the last elements (filter, heater, etc) the water goes through. - Page 4 The sample is taken from the water and sent to the pH flow Cell cell for measurement and returned to the system. The cell (3) needs to be in the housing making sure that the open outer zone Suction Collector coincides with the water inlet tube.
-
Page 5: Water Preparation
Water Preparation The hose from the pH chemical tank is Preferably use water from the urban network. If the water is sourced with a different resource, please analysed it and make sure there is no adverse factors connected to the lower such as a high concentration of metals or calcium for working of the system . - Page 6 The salt dissolving process can be accelerated using the pool cleaner. Check the salt in automatic mode, and the drop mark indicates that the dosing pump is running. Using the arrows on the main screen, a chlorine production rate of 0% (chlorine production stopped) to 100% (full concentration is between 5 and 6kg/m3 using a measurement kit of any pool shop.
- Page 7 pH Mode Setup When a pole is changed, it switches to standby mode for 10 minutes and the screen shown The pH option menu is the first option to oppose pH mode. This option is the menu below is displayed (the hourglass). associated with the operation of the dosing pump.
- Page 8 PH Auto: Measuring the pH dosing pump according to the supplied pH meter and adjusting the stopping value according to the measurement. PH BUF.SEC : This menu selects whether the dosing pump is connected to a pH-increaser or pH-reducer chemistry. In this case, the pH-increasing chemistry-dependent dosing pump is prevented from further increasing the already high pH.
-
Page 9: Fault Message
When the above text is displayed on the screen, put the electrode in the pH cell into the CONNECTED IF THE PUMP IS NOT WORKING OR THE WATER IS NOT FLOWING FREELY. pH 4 liquid supplied with the product and press the OK button. THE POWER SUPPLY OF THE CHLORINATOR SHOULD DEPEND ON THE PUMP’S POWER SUPPLY. -
Page 10: Technical Characteristics
Once clean, rinse the cell immediately with freshwater, dry the terminal area Models GSC 10 GSC 20 GSC 30 Maximum Flow 450 lt/min. 450 lt/min. 450 lt/min. properly and reinstall it in the housing Maximum Pressure 320 kpa 320 kpa 320 kpa Do not leave the cell in the acid solution for longer than 5 min. - Page 11 e. Pump over 1.5 V without installation of a “By-Pass” (according to assembly diagram on page 4) f. If acids are poured into the skimmers without having disconnected the rectifier. g. Use of a tank of acid inside the purification housing and/or the machine chamber with insufficient ventilation.