Advertisement
Storing Channels Automatically
You can scan for the frequency ranges available to you (availability depends on your country).
Automatically allocated programme numbers may not correspond to actual or desired
programme numbers. However you can sort numbers manually and clear any channels you
do not wish to watch.
1
Press the MENU button to display the menu.
2
Press the ▲ or ▼ button to select Channel, then press the ENTER button.
Press the ▲ or ▼ button to select Auto Store, then press the ENTER button.
4
Press the ▲ or ▼ button to select the channel source to memorize. Press the ENTER
button to select Start.
➢
Digital & Analogue: Digital and Analogue channels.
Digital: Digital channels.
Analogue: Analogue channels.
5
Press the ▲ or ▼ button to memorize the channels of the selected connection, then press the ENTER button.
➢
Air: Air antenna signal.
➢
Cable: Cable antenna signal.
➢
Scans for all channels with active broadcast stations and stores them in the TV's memory.
➢
If you want to stop Auto Store, press the ENTER button.
The Stop Auto Store? message will be displayed.
Select Yes by pressing the ◄ or ► button, then press the ENTER button.
Troubleshooting
Before contacting the Samsung after-sales service, perform the following simple checks.
If you cannot solve the problem using the instructions below, note the model and serial number of the television and contact your local dealer.
No sound or picture
Normal picture but no sound
No picture or black and white
picture
Sound and picture
interference
Blurred or snowy picture,
distorted sound
Remote control malfunctions
Screen is black and power
indicator light blinks steadily
The damaged picture appears
in the corner of the screen.
The "Resets all settings to
the default values" message
appears.
•
Check that the mains lead has been connected to a wall socket.
•
Check that you have pressed the
POWER button on the remote control.
•
Check the picture contrast and brightness settings.
•
Check the volume.
• Check if Select Speaker is set to External Speaker.
•
Check the volume.
•
Check whether the volume MUTE M button on the remote control has been pressed.
•
Adjust the colour settings.
•
Check that the broadcast system selected is correct.
•
Try to identify the electrical appliance that is affecting the television, then move it further away.
•
Plug the television into a different main socket.
•
Check the direction, location and connections of your aerial.
•
This interference often occurs due to the use of an indoor aerial.
•
Replace the remote control batteries.
•
Clean the upper edge of the remote control (transmission window).
•
Check that the + and – ends of the batteries are inserted correctly.
•
Check that the batteries are drained.
•
On your computer check; Power, Signal Cable.
•
The TV is using its power management system.
•
Move the computer's mouse or press any key on the keyboard.
•
On your equipment check (STB, DVD, etc) ; Power, Signal Cable.
•
The TV is using its power management system.
•
Press the Source button on the panel or remote control.
•
Turn the TV off and on.
•
If Just Scan is selected in some external devices, the damaged picture may appear in the
corner of the screen. This symptom is caused by external devices, not TV.
•
This appears when you press and hold the EXIT button for a while. The product settings are
reset to the factory defaults.
(Power) button (On/Off) on the front panel or press the
Country
Auto Store
Manual Store
Full Guide
Mini Guide
Default Guide
: Mini Guide
Channel List
Channel Mode
: Added Ch.
Fine Tune
►
Advertisement
