Download Print this page
Znshine Solar Mono-Si Series Mounting Manual

Znshine Solar Mono-Si Series Mounting Manual

Double glass with frame solar module

Advertisement

Quick Links

INSTALLATION INSTRUCTION FOR DOUBLE GLASS WITH FRAME SOLAR MODULE
Double glass with frame solar modules are made of crystalline solar cells in series with high efficiency, high
transmission and low iron toughened glasses , anti-aging EVA and high flame-resistant back sheet to laminate,
and anodized aluminum alloy frame. Products have high efficiency, lifespan easy installation, high wind
resistance etc.
Products are made according to international standard IEC61215-2016; IEC61730-2016 and have passed
authority test center's examination. Our products can be used in home roof solar systems, PV stations,
communication stations, petrol, ocean, meteorological, traffic and solar building etc.
Information for installers
Installers must read and understand this manual before installation.
Please ensure that installation, operation and maintenance of your photovoltaic system is only carried
out by qualified persons able to carry out the technical procedures described in this manual, i.e. system planers,
installers and maintenance personnel, and is carried out in accordance with all safety precautions in this manual
and any and all applicable local codes. If you do not possess these qualifications, you may not carry out the work
described herein except for cleaning.
This manual and the instructions set forth herein are part of the product and should therefore be kept for
the entire useful life of the solar installation.
Information for operators
Keep these instructions safe for the entire useful life of the solar installation.
Please contact your plant supplier for information concerning the formal requirements for solar systems.
Please be sure to learn about directives and permit requirements from the responsible local authorities and
energy providers prior to installation of the solar plant.
We recommend that you insure your solar system against natural hazards (e.g. against lightning strikes).
正信光电科技股份有限公司
ZNSHINE PV-TECH CO.,LTD
Mounting Manual

Advertisement

loading

Summary of Contents for Znshine Solar Mono-Si Series

  • Page 1 正信光电科技股份有限公司 ZNSHINE PV-TECH CO.,LTD Mounting Manual INSTALLATION INSTRUCTION FOR DOUBLE GLASS WITH FRAME SOLAR MODULE Double glass with frame solar modules are made of crystalline solar cells in series with high efficiency, high transmission and low iron toughened glasses , anti-aging EVA and high flame-resistant back sheet to laminate, and anodized aluminum alloy frame.
  • Page 2 1、 Electrical Specification Mono/Poly-Si series PHOTOVOLTAIC MODULE Model ZXM6-LD72 ZXM6-LD60 ZXP6-LD72 Max series fuse rating(A) Nominal Mass(kg) 26.5kg/25.5kg 18kg/21.5kg 26.5kg/25.5kg 1978x992x25/27/30/35 1658x992x25/27/30/35 1978x992x25/27/30/35 Package Size(mm) 2000x1002x25/27/30/35 1678x1002x25/27/30/35 2000x1002x25/27/30/35 158.75mm×158.75mm/156.75mm×156.75mm Cell Size DC1500V System voltage Class A Application class...
  • Page 3: Operating Environment

    ● The electrical characteristics are within ±3 percent of the indicated values of Isc, Voc and Pmpp under test conditions (irradiance of 1000W/cm ,AM1.5 spectrum, and a cell temperature of 25℃) ●Under normal conditions, a photovoltaic module is likely to experience conditions that produce more current and/or voltage than reported at standard test conditions.
  • Page 4 ● The installation of project must be facing north in the southern hemisphere, and facing south in the northern hemisphere, the electricity will be comparatively lower when the project facing west or east. The incorrect installation will lead to the loss of power RECOMMENDED TILT ANGLES FOR A FIXED SYSTEM SITE LATITUDE IN DEGREES FIXED TILT ANGLE...
  • Page 5 ● Use the holes(5.0mm) marked ' '. To create the conductive connection (frame is anodized), use Stainless steel M5nut, two Stainless steel cut washer, Stainless steel M5 plain washer, Stainless steel M5 spring washer , M5 copper wire ,and Stainless steel M5 bolt. 1.
  • Page 6: Installation Direction

    6、Mounting Clamping installation Modules can be installed with clamps. Modules must be securely attached to the mounting structure with four clamps on the long frame. The modules must be properly secured to their support so that they can withstand live load condition, ...
  • Page 7 +5400Pa/-3600Pa ≥150mm (6 clamps with 3 rails) Use a torque wrench for installation, and the compression for each clamps is not strong to avoid potential  damages to module frames. The recommended maximum compression for each clamp is 20MPa (2900PSI). The module mounting structure must be made of durable, corrosion-resistant and UV-resistant material.
  • Page 8: Maintenance And Cleaning

    7、Wiring ● The modules use the PV-JX1203 type junction box. This box, on the back side of the module, is weatherproof and is designed to be used with standard wiring or conduit connections. Wiring methods should be in accordance with the NEC (National Electrical Code). Bypass diodes and cable clamps are included with each module when shipped from the factory.
  • Page 9 10、Danger of death from electric shock! Solar modules generate electricity as soon as they are exposed to light. One module on its own is below the safety extra low volt level, but multiple modules connected in series (summing the voltage) or in parallel (summing the current) represent a danger.
  • Page 10 ZX X X XX XX XX XXXX flow coding (4digit) 第 11.12 位数字码 production date (2digit)Two numbers minus 12 is the actual date 第 9、10 位数字码 production month (2digit)Two numbers minus 18 is the actual 第 7、8 位数字码 Producing year (2digit)Two numbers minus 15 is the actual year 第...
  • Page 11 12 TECHNICAL DATA 组件系列 Module Series 72pcs 158.75×158.75mm Monocrystalline Silicon Module 尺寸(mm)/重量(kg) Dimensions(mm)/ Weight(kg) 2000x1002x25/27/30/35 系统电压(VDC) 1500 Max-System Voltage (VDC) 最大保险丝额定电流(A) Max-Series Fuse(A) 电气参数(标准测试条件下) Electrical Performance @ STC ZXM6-LD72-380 ZXM6-LD72-385 ZXM6-LD72-390/ ZXM6-LD72-395 组件类型 Model Type 最大功率 Max-Power Pm(W) 最大功率点的工作电压 39.8 40.2 40.4 Max-Power Voltage V...
  • Page 12 开路电压 40.2 40.6 Open Circuit Voltage Voc(V) 开路电流 10.05 10.25 Short Circuit Current Isc(A) 组件系列 72pcs 156.75×156.75mm Polycrystalline Silicon Module Module Series 尺寸(mm)/重量(kg) 1978x992x25/27/30/35 Dimensions(mm)/ Weight(kg) 系统电压(VDC) 1500 Max-System Voltage (VDC) 最大保险丝额定电流(A) Max-Series Fuse(A) 电气参数(标准测试条件下) Electrical Performance @ STC 组件类型 ZXP6-LD72-345/P ZXP6-LD72-350/P ZXP6-LD72-355/P...

This manual is also suitable for:

Poly-si seriesZxm6-ld72Zxm6-ld60Zxp6-ld72