Declaration Of Conformity For Wireless Vehicle Components; Diagnostics Connection - Mercedes-Benz GLE Operator's Manual

High voltage components may be damaged
in an accident, although the damage may not
be visible.
Never perform modifications to compo‐
#
nent parts of high-voltage components.
Never touch damaged component parts
#
of high-voltage components.
Never touch component parts of high-
#
voltage components after an accident.
Vehicles with a 48 V on-board electrical system
contain high voltage components. These compo‐
nents are marked with a high voltage label:
All work on high voltage components must be
carried out at a qualified specialist workshop.
Declaration of conformity for wireless vehi‐
cle components
USA: "Radio based devices of this vehicle com‐
ply with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1) These
devices may not cause harmful interference, and
2) These devices must accept any interference
received, including interference that may cause
undesired operation. Changes or modifications
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment."
Canada: "This vehicle contains license-exempt
transmitter(s)/receiver(s) that comply with Inno‐
vation, Science and Economic Development Can‐
ada's RSS(s). Operation is subject to the follow‐
ing two conditions: (1) These devices may not
cause interference, and (2) These devices must
accept any interference, including interference
that may cause undesired operation of the
device."
General notes
USA: "Wireless charging system for mobile devi‐
ces (model: WMI2 Wireless Mobile Interface):
This device complies with Part 18 of the FCC
Rules."
The name and address of the responsible party
is:
peiker acustic GmbH
Max-Planck-Str. 28-32
61381 Friedrichsdorf
Germany

Diagnostics connection

The diagnostics connection is only intended for
the connection of diagnostic devices at a quali‐
fied specialist workshop.
& WARNING Risk of accident due to con‐
necting devices to the diagnostics con‐
nection
If you connect devices to the diagnostics
connection of the vehicle, the function of
27