Advertisement
+12V
1.5K
LED
Use the Normally Open (N.O.) output contact to shunt a Normally Closed (N.C.) protection zone
of an alarm system.
Set output contact to Start / Stop Mode (Programming Option 51).
Use the (N.O.) or (N.C.) output contact to make arm-disarm control of an alarm system.
Consult your alarm control panel manual for the appropriate output contact to be used in arm-disarm control.
Usually set output 2 to Momentary mode (Programming Option 501) for multi station systems and Start
/ Stop mode (Programming Option 51) for single station systems.
LOW POWER
PIEZO BUZZER
N.C.
N.C. MAGNETIC CONTACT
OR
33
TO PROTECTION ZONE
OF AN ALARM CONTROL PANEL
REMOTE
ARM-DISARM
CONTROL
NO. OR N.C.
24 HOUR N.O.
PROTECTION
ZONE
Advertisement
