RDT FloodMaster RS-094-MK6 Manual

Plenum-Rated Water Heater / Tank Leak
Detection & Automatic Shut-Off System
with Step-Down Transformer & Plenum-Rated Wires
Congratulations on your purchase of a FloodMaster RS-094-MK6 plenum-rated water heater leak detection
system from Reliance Detection Technologies. This product is designed to automatically shut off the water
supply to a water heater or tank if a leak is detected.
To ensure proper installation and to maximize the performance of your RS-094-MK6 water leak detection
system, please read this manual thoroughly before installing or operating the system.
PLEASE READ CAREFULLY BEFORE PROCEEDING: If a leak is detected, the RS-094-MK6 will shut off the
water going to the water tank. This will stop the continuous flow of water from the water supply to the tank.
However, all or some of the water that is already in the tank may still leak out onto the floor.
NOTE: This installation and operating manual contains important information about the operation of the
RS-094-MK6 system. If this system is being installed for use by a different user, please be sure a copy of
this manual is left with the system for future reference.
Warning: For use with water only. Do not install on gas line. Never install this device
on a fire protection or fire suppression system. For indoor use only.
www.RelianceDetection.com
RS-094-MK6 System Components (included in kit):
1 – Receiver box / actuator
1 – Full port lead-free shut-off valve
(NSF/ANSI 61 and 372)
1 – Water sensor with 8' lead wire
RS-094-MK6
Toll-Free: 888-771-4929
1 – Metal plate for sensor placement
1 – Step-down transformer (120, 208, 240V AC
to 24V AC ) and mounting plate