Samsung PS63B680T6W User Manual page 39

Option
Network Setup
When unable to connect to an AP(Access Point)
Your TV may fail to locate an AP(Access Point) that is configured as a private SSID type.
In this case, please change the AP settings and try again. If your Internet service provider
has registered the MAC address of the device used to connect to the Internet for the first
time and authenticates the MAC address each time you connect to the Internet, your TV
may not be able to connect to the Internet as the MAC address differs from that of the
device (PC).
In this case, ask your Internet service provider about the procedures to connect devices our Internet service provider about the procedures to connect devices
other than your PC (such as your TV) to the Internet. If you cannot connect to the Internet
even if you have followed the procedures of your Internet service provider, please contact
a Samsung Electronics at 1-800-SAMSUNG.
Setup
Description
■ Ad-hoc: You can connect to a mobile device without
an access point through the 'Samsung Wireless LAN
Adapter' by using a peer to peer network.
How to connect to new Ad-hoc
1. Choose Select a network, then a device list is
displayed.
2. While in the device list, press the Blue button on the
remote or select Ad-hoc.
•
The message that means the existing network
is disconnected is displayed.
3. Input the generated Network Name(SSID) and
Security Key into the device you want to connect.
How to connect an existing Ad-hoc device
Select a network, the device list is
1. Choose
displayed.
2. Select the device you want in the Device list.
3. If security
key was applied, input the security key again.
•
If network doesn't operate normally, please
check the Network Name(SSID) and Security
Key again. If the Security Key is incorrect, it
may be the reason for the malfunction.
■ Wireless Network Setup-Auto
If you want to connect AP, AP should support DHCP.
Only devices which support Ad-hoc mode can be
connected without DHCP.
1. Set Network Type to Wireless.
2. Select Wireless Network Setup.
3. Set Internet Protocol Setup to Auto.
•
The Internet Protocol is set automatically.
4. Select a network through Select a network through Select a network through Select a network.
5. Select Network Test to check the network connectivity.
■ Wireless Network Setup-Manual
1. Set Set Network Type to Wireless. Set
2. Select Select Select Wireless Network Setup.
3. Set Set Set Internet Protocol Setup to Manual.
4. Set up Set up IP Address, Subnet Mask, Gateway and DNS Set up
Server.
•
Press the number buttons on the remote control
when you set the Network manually.
5. Select Select Network Test to check the network connectivity. Select
The existing network system may have limited
functionality. Do you want to change the network
connection?
Yes No