Banks - Qu-Bit Electronix Tri-ger Manual

11. Rec:
Button that, when pressed, will record-enable the Tri-ger. When it is held down, it will
allow the user to punch in record. (See Getting Started: Recording New Loops,
Punch In/Punch Out Recording, and Momentary Punch In Recording for more
information).
12. Alt:
Alternate button that, when pressed, gives the Tri-ger's LED buttons a secondary and
tertiary function.
Alt + Play/Pause =
Alt + Retrigger
Alt + Roll
13. Rec/Mute Indicators:
LED indicators that show the current state of specific channels (See Getting Started:
Muting Specific Channels and Enabling/Disabling Drum Rolls On Specific
Channels for more information).
14. Bar/Beat Indicators:
LED indicators that show the current location within a recorded loop. These indicators
assume that the recorded pattern is in the 4/4 time signature.

Banks

To access the Tri-ger's 8 banks, hold down the alt and rec buttons until all bar/beat
indicators illuminate. Release buttons and a single bar/beat indicator will blink,
showing which bank is currently active.
The alt button will cycle through each bank in numerical order.
The rec button will load the highlighted bank and exit the bank menu.
The play/pause button will exit the bank menu without loading a new bank.
If the rec/mute indicators are red when a bank is highlighted, the bank is full.
If the rec/mute indicators are green when a bank is highlighted, the bank is empty.
All empty banks will load the currently recorded pattern upon selection.
Each bank can be rewritten with entirely new patterns of different lengths.
9
Trigger 1
= Trigger 2
= Trigger 3