Advertisement
• Connecting multiple control panels
Make a daisy-chain connection to the [DCP] connector of the MTX when multiple control panels are
connected. Up to eight control panels can be connected. Keep in mind that the total maximum length of
cables between the MTX and the terminated control panel is 200 meters.
LhCAUTION
Do not connect control panels to any connector other than the
[DCP] connector of the MTX. Doing so can result in damage to the
devices or even fire since they are not electrically compatible.
Up to eight units can be connected.
[DCP] connector
(RJ-45)
~:
---o--__,
0
Fix the control panel to the wall box.
NOTE
• Use a suitable wall box: 1-gang with a depth of 44
millimeters or more for the DCP4S-US, and 3-gang
with a depth of 44 millimeters or more for the
DCP4S-EU.
• Use proper screws that fit the size of wall box.
• Tighten the screws with a torque of less than 1.5
Nm. Also, make sure that the screw heads extend
from the control panel by no more than 3
millimeters.
8
Put the plastic cover on the control panel.
Push the plastic cover all the way, until it clicks in
place.
DCP4S-US
0
J
..,.
';'S
I
Wall
bL
(US-type)
Plastic cover
Control panel
Total maximum cable length is 200 meters.
Terminate the last control panel.
DCP4S-EU
00
rrn~~··
~
I
CJ
Wall
bL
(UK-type)
Plastic cover
Control panel
*
Screws for attaching the control panel and wall box
are not included.
NOTE
(DCP4S-EU only)
When attaching to a surface mount box, insert the
included plastic spacers to fill the gap between the
box's edge and the face of screw holes of the box.
Adjust the height of spacers if needed.
NOTE
When detaching the plastic cover, insert a slotted
screwdriver into the small release slot at the bottom of
the cover, then pull up gently to remove it. Be careful
not to damage the plastic cover.
II
Other S e t t i n g s - - - - - - - - - - - - - - - - - - -
using the MTX Editor, the following functions are available. Refer to the MTX Editor User's Manual for details.
• The brightness of the control panel can be set according to the brightness of the room.
• The control panel can be locked to avoid it being utilized by unauthorized persons.
• Error messages are shown on the control panel by a combination of the LEOs turning on, off and blinking.
Advertisement
