Advertisement
Instructions For Installing GA3450T
GA3450T for use on CGCF26T Series Compact Fireplace
Carton Contents
Description
Bracket
Thermodisc
Blower
Wire Harness
Power Cord
AUTO/OFF/ON switch
Mounting Hardware kit
WARNING
Fan accessory must be grounded. Fan comes
with a three-prong, grounding plug as shown
in Figure 1. The plug is your protection against
electrical shock. Plug it into a standard,
three-hole, grounded, outlet. If cord needs
replacing, use only a cord with a three-prong,
grounding plug.
NOTICE
Cord length from switch plate assembly to plug
is six feet. Make sure grounded outlet is an
appropriate distance from unit.
Removing Upper Louver Assembly
To install the blower accessory, you must first remove the upper louver assembly.
CGCF26T Series
1. Lift screen off heater.
2. Remove 2 screws from louver assembly (see Figure 2). Save these screws.
3. Pull louver assembly straight out from the cabinet. Be careful not to scratch the paint. Set louver assembly and
screws aside.
Thermostat Blower Accessory
Part Number
103966-01
103972-01
103283-01
103968-01
104015-01
099998-01
098418-08
Figure 2 - Removing Upper Louver Assembly
Hardware kit contains
2 Plastic snap bushings
6 #10 screws
1 Plug button
If any of these pieces are missing or damaged, contact the
dealer where you purchased this kit or DESA Interna-
tional at 1-800-972-7879 for referral information.
Grounded Outlet
Figure 1 - Grounding Plug
WARNING
Failure to connect all wires as indicated may
cause electrical shock or personal injury.
Blower Bracket
Mounting Holes
Upper Louver
Assembly
Grounding Plug
Continued
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Comfort Glow GA3450T
Summary of Contents for Comfort Glow GA3450T
- Page 1 Instructions For Installing GA3450T Thermostat Blower Accessory GA3450T for use on CGCF26T Series Compact Fireplace Carton Contents Hardware kit contains Description Part Number 2 Plastic snap bushings Bracket 103966-01 6 #10 screws Thermodisc 103972-01 1 Plug button Blower 103283-01 If any of these pieces are missing or damaged, contact the...
- Page 2 Standard Installation Removing Valve Cover Shield Shoulder 1. Open bottom louver assembly by swinging Screw the assembly down (see Figure 3). Remove 2. Using short Phillips screwdriver, remove the Screw Valve screw under the center of the branch support. Cover Rotate valve cover shield clockwise and slide Shield out.
- Page 3 9. Install the switch plate on the valve cover shield with 2 #10 screws provided (see Figure 5, page 3). Reinstall the valve cover shield. Route power cord out Valve Cover Shield of the cabinet by inserting it through the bushing on the outer casing (see Figure 4).
- Page 4 Extension Cord Fan Switch Use extension cord if needed. The cord must have a (Auto/Off/On) Auto three-prong, grounding plug and a three-hole receptacle. Make sure cord is in good shape. It must be heavy Thermostat Blue Switch enough to carry the current needed. An undersized cord (N.O.) will cause a drop in line voltage.
Need help?
Do you have a question about the GA3450T and is the answer not in the manual?
Questions and answers