Operating Instruction Digital Grease Meter Content General details ______________________________________________________________________4 1.1. History of documents _________________________________________________________________4 1.2. Intended operation __________________________________________________________________4 1.3. Construction and description of operation ________________________________________________4 1.4. Technical details _____________________________________________________________________4 General safety advises ________________________________________________________________5 2.1. Advises for the saftey at work __________________________________________________________5 2.2.
Operating Instruction Digital Grease Meter General details History of documents Date Name Version Modification 24.04.2009 1.00 Creation 10.06.2009 1.01. Re-designed after completition 19.02.2009 1.02 Revise of programming 15.04.2010 1.03 Extended manual K-factor calibration, time-controlled reset to TOTAL Intended operation The grease meter has been developed and constructed for accurate measurement and registration of ■...
Operating Instruction Digital Grease Meter General safety advises Advises for the saftey at work The grease meter has been designed and manufactured with respect to the general safety and health ■ ■ requirements of the relevant EU directives. However this product might be dangerous if it is not operated according to the intentions of the ■...
Operating Instruction Digital Grease Meter Installation The grease meter shows a straight inlet and outlet with G 1/8“ female thread connection on both sides. The grease meter can be installed in any position, as part of a fixed in-line installation or as a mobile installation connected to a grease gun.
Operating Instruction Digital Grease Meter The pushbutton TOTAL switches the display to TOTAL. RESET short resets the counter partial volume back to zero to start a new measuring process. The partial volume will be displayed automatically when dispensing. 5 seconds after dispensing or after the manual switch to partial volume (using TOTAL short) the display will automaticlly reset to Total.
Operating Instruction Digital Grease Meter Maintenance The grease meter is designed for a utilization requiring low maintenance efforts, only. See the following details: Exchange of empty batteries. ■ ■ Exchange of batteries The meter will be supplied with two 1,5V alcaline batteries. Attention! Please dispose the empty batteries according to local regulation, only.
The grease meter has been designed and manufactured with respect to the highest quality standards. Should a quality problem appear despite of all qualtity precautions please contact our customer’s service. FMT Swiss AG Tel +49 9462 17-216 Fax +49 9462 1063 service@fmtag.ch...