SAFETY INSTRUCTIONS Safety Instructions For your safety,the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury or loss of life. Explanation of the symbols: ! Warning! This combination of symbol and signal word indicates a potentially dangerous situation which may result in...
Page 4
SAFETY INSTRUCTIONS The new hose-sets supplied with the appliance are to be • used and that old hose-sets should not be reused. • Before any maintenance the device, unplug the appliance from the mains. • Always unplug the machine and turn off the water supply after use.
Page 5
SAFETY INSTRUCTIONS • Glass door may be very hot during operation. Keep kids and pets far away from the machine during the operation and do not use the machine in very wet rooms as well as in rooms with explosive or caustic gas. •...
Page 6
SAFETY INSTRUCTIONS • The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the washer dryer. • The appliance shall not be installed at a humid place. •...
Page 7
SAFETY INSTRUCTIONS • Make sure that all pockets are emptied. Sharp and rigid items such as coin,brooch,nail,screw or stone etc. may cause serious damages to this machine. • Please check whether the water inside the drum has been drained before opening its door.Please do not open the door if there is any water visible.
Page 8
SAFETY INSTRUCTIONS Items such as foam rubber (latex foam), shower caps, water proof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the machine. Fabric softeners, or similar products, should be used as specified by the fabric softener instructions.
INSTALLATION Product Description Top cover Water supply hose Control panel Power supply cord Detergent dispenser Drum Door Service filter Drain hose Note! • The product line chart is for reference only, please refer to real product as standard. Accessories Transport Drain hose support Owner’s manual...
INSTALLATION Installation Installation area Warning! ! • Stability is important to prevent the product from wandering! • Make sure that the product should not stand on the power cord. W> 20mm Before installing the machine, the location characterized follows shall be selected: 1.Rigid, dry, and level surface 2.Avoid direct sunlight 3.Sufficient ventilation...
Page 11
INSTALLATION Levelling the washing machine ! Warning! • The lock nuts on all four feet must be screwed tightly against the housing. 1.Check if the legs are closely attached to the cabinet. If not, please turn them to their original positions tighten the nuts. 2.
Page 12
INSTALLATION Connect the other end of inlet pipe to the inlet valve at the backside of product and fasten the pipe tightly clockwise. water supply hose water Inlet valve Drain Hose ! ! Warning! Warning! • Do not kink or protract the drain hose. •...
OPERATIONS Quick Start Caution! • Before washing, please make sure it’s installed properly. • Before washing at first time, the washing machine shall be operated in one round of the whole procedures without clothes in as follows. Calibration It is recommend to calibrate the washing machine before first use 1- Empty the wash machine;...
OPERATIONS Before Each Washing • The working condition of the washer should be(0-40)℃.If used under 0℃,the inlet valve and draining system may be damaged. If the machine is placed under condition of 0℃or less, then it should be transferred to normal ambient temperature to ensure the water supply hose and drain hose are not frozen before use.
OPERATIONS Pre wash detergent Main wash detergent Softener Pull out the dispenser Caution! Detergent only need to be added in "case I after selecting pre-washing for machines with this function. Programme Programme Cotton Wool ECO 40-60 Synthetic Intensive Bed Linen Quick 15...
Page 17
OPERATIONS Option Delay Set the Delay function: Select a programme; 2.Press the Delay button to choose the time(the delaying time is 0-24 H.); Press [Start/Pause] to commence the delay operation Delay Setting time Start Choose the Programme Cancel the Delay function: Press the [Delay] button until the display be 0H.It should be pressed before starting the programme.
Page 18
OPERATIONS Reload This operation can be executed during the washing progress. When the drum is still rolling and there is large amount of water with high temperature in the drum. The state is unsafe and the door cannot be opened forcefully. To press [Start/Pause] for 3 sec.
OPERATIONS Other Functions Temp. Press the button to regulate the temperature(Cold,20 ℃, 30℃, 40℃,60℃,90℃) Speed Press the button to change the speed. 1500: 0-400-600-800-1000-1200-1400-1500 Programme Programme Default Speed(rpm) Default Speed(rpm) 1500 1500 Cotton 1500 Spin Only 1000 Rinse &Spin 1000 Wash and Dry Wool 1500...
Page 20
OPERATIONS Child Lock To avoid mis operation by children. Press [ ] and [ Delay SpaCare Delay SpaCare 3 sec. till buzzer beep. Caution! Caution! When child lock is activated and program starts, child lock indicator will switch on, and the CL and remaining time on the display are alternately displayed in 0.5s. Press the other buttons will make child lock indicator flash for 3s.
MAINTENANCES Cleaning And Care ! Warning! • Before your maintenance starts, please unplug the machine and close the tap. Cleaning The Cabinet Proper maintenance on the washing machine can extend its working life. The surface can be cleaned with diluted non-abrasive neutral detergents when necessary.
Page 24
MAINTENANCES Cleaning The Inlet Filter Note! • Inlet filter must be cleaned if there is less water. Washing the filter in the tap Close the tap. Remove the water supply hose from the tap. clean the filter. Reconnect the water supply hose. Washing the filter in washing machine: Screw off the inlet pipe from the backside of the machine.
Page 25
MAINTENANCES Cleaning The Drain Pump Filter ! Warning! Be careful of the hot water! • • Allow detergent solution to cool down. • Unplug the machine to avoid electrical shock before washing. • Drain pump filter can filter the yarns and small foreign matters from the washing.
MAINTENANCES Trouble Shooting The start of the appliance does not work or it stops during operation. First try to find a solution to the problem, If not, contact the service centre. Description Reason Solution Washer dryer Restart after the door is closed Door is not closed properly cannot start up Check if the clothes is stuck...
Washing Capacity Dimension Net Weight Rated Power (W*D*Hmm) 1900W CIW-10715 10.0kg 595*565*850 74kg The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of machine washable wool products provided that the products are washed according to the instructions on the garment label and those issued by the manufacturer of this washing machine.M1529...
87A, 17th November str, 55535, Pylea, Thessaloniki CIW-10715...
Page 30
MAINTENANCES CIW-10715 Model 10kg Washing Capacity Drying Capacity 1500 rpm Spin Speed Energy efficiency class 6.8kwh/Cycle Energy consumption of per cycle (to wash and dry a full capacity wash load at 60°C) 160 L/cycle Water consumption of per cycle(Total) 1360kWh /annual...
Page 31
MAINTENANCES Note! • Programme setting for testing in accordance with applicable standard En60456 for wash. • Programme setting for testing in accordance with applicable standard En50229 for wash and dry. • When using the test programmes, wash the specified load using the maximum spin speed.
Page 32
Low Voltage Directive: 14/ 35 / EU ErP Directive 09 / 125 / EC CE Marking: 93 / 68 / EEC RoHS Directive: 11 / 65 / EU & Delegated Directive (EU) 15 / 863 The detailed declaration of conformity can be found at www.morris.gr...
Need help?
Do you have a question about the CIW-10715 and is the answer not in the manual?
Questions and answers