(Power Failure cont'd.)
3.
The lower boom can only be lowered by draining the fluid from the lower cylinder. To drain, use an appropriate container
for the fluid and loosen the hydraulic fitting located at the base of the lower cylinder. DO NOT completely remove the
fitting. Loosen the fitting only slightly to begin a slow, controlled rate of descent. Tightening the fitting will stop the
movement of the boom.
DANGER:
SEE SAFETY PRECAUTIONS ON PAGE 4-8 BEFORE USING JUMPER CABLES
NOTE: Make certain vehicles
do not touch
1.
Connect positive (+) cable to positive post of discharged batteries.
2.
Connect other end of booster cable to positive (+) post of booster battery.
3.
Connect second cable to negative (-) post on booster battery.
4.
Make final connection on unit frame away from battery to prevent sparking.
5.
Remove cables in reverse order of installation.
4520362-1/0606
Figure 2-1
Booster Cable Instructions
Page 2 - 2 - Emergency Procedures
Courtesy of Crane.Market