Advertisement
CHS Series
10. Branch – Insert the 6" x 4" Branch fittings into the
4" Elbows installed in Step 9, starting with the boiler on
the left (start with the boiler on the right if the Exhaust
Gas is being piped to the left). Use Centrocerin lubricant
and a Connector Ring at each connection.
NOTE: Exhaust gas branches are piped to the right; therefore
Branches are required to be cut to an overall length of 33"
Horizontal
Drain
6" Connector
Ring
Branch
Drain
Fitting
11
12. Exhaust Support – Secure the Exhaust Manifold
in place by installing the tops of the Exhaust Supports
using 1/4" x 1" Machined Screws.
CHS 300-399 Common Venting
4" Connector
Elbow
Branch
10
11. Horizontal Drain – Install the Horizontal
Drain onto the left side (male end) of the
Exhaust Manifold (if Exhaust Gas is being
piped to the left, install Horizontal Drain on the
right side of the Manifold). Use Centrocerin
lubricant and a Connector Ring at each
connection.
Top of Exhaust Support
& 1/4" x 1" Machined
Screws
12
│
Slant Fin Corp.
Ring
14
Advertisement
