SUSPENZ SUP Stow & Go System Mounting Instructions

SUP Stow & Go System
Tools Needed : Tape Measure, Electric Drill, ³/₁₆" Drill Bit,
and #3 Phillips Head Driver
1. Locate the wall studs where Stow & Go System will be mounted. The recommended
spacing is 16" apart to allow for stud placement.
2. Use a Mounting Bracket as a template to mark the hole locations. Push a mounting
screw into wall to mark the locations for holes.
Pro Tip: An old woodworkers trick is to rub the screw
threads on a bar of soap for easy installation.
3. Use the ³/₁₆" drill bit to drill both holes. It is important that these go into a wood stud.
4. Use #3 Phillips Head Driver to insert screws through bracket and into holes. Repeat
for second bracket.
5. Adjust the strap lengths to gently cradle your SUP or surfboard.
For Technical assistance or Replacement parts: call 866.787.7369
Rev. 11/17
Suspenz®, Inc.
8725 Roswell Road #0-220
Atlanta GA 30350
Model # 22-4022
Parts List
Qty
1 Stow & Go Strap
2 Mounting Bracket
4 Philips Head Screw
1 Nylon Storage Bag
Holds up to 100 LBS
.
.
.
Customer Service:770-518-0045
Website: www.suspenz.com
Name
Fax: 770-518-8507