Advertisement
with a wide variety of simulated aircraft and is sure to make your flight simulation experience more
realistic and enjoyable.
The steps below will assist in the installation, configuration and operation of the GF-SECM. Following
these instructions will help to get you up in the "virtual skies" as quickly as possible.
Connecting the USB Cable
To connect the SECM to your computer, use the 2-meter USB cable provided in the package, following
these steps:
1. Plug the USB cable "B" connector end (square) into the connector on the back of the GFSECM
enclosure.
2. Plug the USB cable "A" connector end (rectangular) to a USB port on your computer or hub.
The first time the SECM is connected to the USB port on a computer running Microsoft Windows, a
message "New Hardware Found" or "Your New Device is Now Ready" should appear briefly on your
screen. This indicates that Windows has detected the SECM, and has loaded all required drivers.
From this point on, if you disconnect the SECM and then re-connect it, the drivers will automatically
load and no message will appear on the screen. This also occurs each time you re-start your computer
while the SECM is connected. The automatic loading of drivers, with no notification message, is a
normal operating feature of the Windows Plug and Play system.
Software Installation
NOTE If you own other GoFlight hardware and have already installed the most current
version of software on your system, you do not need to install the software again.
Simply skip the software installation steps in the instructions below.
3. Get on line and go to
4. On the GoFlight home page click Support.
1
Single Engine Control Module
www.goflightinc.com.
Virtual Pilot Operating Handbook
GF-SECM MANUAL
Cockpit Control System
Congratulations on your purchase of a
GoFlight
GF-SECM
Control Module), part of the extensive
family of GoFlight GF Cockpit Control
System modules.
The GF-SECM is designed to operate
2012
GF-SECM
(Single
Engine
Advertisement
Table of Contents
Related Manuals for GoFlight GF-SECM
Summary of Contents for GoFlight GF-SECM
- Page 1 The steps below will assist in the installation, configuration and operation of the GF-SECM. Following these instructions will help to get you up in the “virtual skies” as quickly as possible.
- Page 2 6. Click “Run” or “Save” and follow the instruction to install the software. If the software installer detects that GoFlight software is already installed on your system, it will prompt you to overwrite. Click the Yes button to overwrite the existing version of GoFlight software.
- Page 3 This product is warranted to the original purchaser to be free from defects in materials and workmanship for a period of one(1) year from the date of purchase. During this warranty period, GoFlight Technologies, Inc. ® (“GoFlight”) will, at its option, repair or replace, at no charge, any component determined to be defective. The liability under this warranty is limited to the repair and/or replacement of the defect or defective part, and does not include shipping expenses.
Need help?
Do you have a question about the GF-SECM and is the answer not in the manual?
Questions and answers