Table of Contents
Advertisement
Quick Links
quickly as possible, the following steps will assist in ensuring the GF-LGTII will be easy to install and
configure.
Installing the GF-LGT II Module
NOTE: If you own other GoFlight hardware and have already installed the most current version of
software on your system, you do not need to install the software again. Simply skip the software
1. Get on line and go to http://www.goflightinc.com. On the home page click on Support/Downloads.
2. Click on Software.
3. Click "Run" or "Save" and follow the instruction to install the software.
If the software installer detects that GoFlight software is already installed on your system, it will prompt
you to overwrite. Click the Yes button to overwrite the existing version of GoFlight software. This is
useful if you wish to keep the configuration settings for other GoFlight modules installed on your system.
However, you should first make sure that the software you are overwriting is an older version and not a
newer one.
4. If you are going to mount the GF-LGT II module into a GF-AC rack, install the module in any desired
location in the rack using the two thumbscrews provided.
1
Landing Gear and Trim Control
installation steps in the instructions below.
Virtual Pilot Operating Handbook
GF-LGT MANUAL
Cockpit Control Module
Congratulations on your purchase of the
GoFlight GF-LGT II Landing Gear and
Trim
Control
Module, part
extensive family of GoFlight Cockpit
Control System modules.
The GF-LGT II is designed to operate
with a wide variety of simulated aircraft,
and is sure to make your simulated flying
more realistic and enjoyable.
To get you up in the "virtual skies" as
2012
GF-LGT
of
the
Advertisement
Table of Contents
Related Manuals for GoFlight GF-LGT
Summary of Contents for GoFlight GF-LGT
- Page 1 However, you should first make sure that the software you are overwriting is an older version and not a newer one. 4. If you are going to mount the GF-LGT II module into a GF-AC rack, install the module in any desired location in the rack using the two thumbscrews provided.
- Page 2 Elevator Trim The wheel on the left side of the GF-LGT II panel is used to adjust your Flight Sim aircraft’s elevator trim. Move the wheel upwards to trim the nose of the aircraft down. Move the wheel downwards to trim the nose of the aircraft up.
- Page 3 This product is warranted to the original purchaser to be free from defects in materials and workmanship for a period of one (1) year from the date of purchase. During this warranty period, GoFlight Technologies, Inc. ® (“GoFlight”) will, at its option, repair or replace, at no charge, any component determined to be defective. The liability under this warranty is limited to the repair and/or replacement of the defect or defective part, and does not include shipping expenses.
Need help?
Do you have a question about the GF-LGT and is the answer not in the manual?
Questions and answers