LG DLE4970 E Series Service Manual page 48

2
THE DRYER DOOR IS VERY LARGE AND HEAVY. Failure to follow the
instructions below can result in damage to the dryer, property damage
or personal injury. The edges of the door cover may be sharp. Take care
when handling, or wear gloves to avoid injury.
1. Open the door so that the hinge screws are accessible.
Be sure to support the weight of the door before removing the
hinge screws.
2. While supporting the door, remove the four hinge screws, two
from each hinge. Set the door aside face down on a protected
surface to prevent damage to the door or the work surface .
Use a Phillips screwdriver to remove the two screws and the latch
mechanism on the front panel of the cabinet.
screwdriver, being careful not to scratch the paint. Install the latch
hole cover on the opposite side, where the latch mechanism was
removed. Install the latch mechanism in the position from which you
removed the latch hole cover, using the two screws removed in step 3.
5.
screwdriver, being careful not to scratch the paint. Rotate the hinge
cover 180 degrees and install it on the opposite side, where the upper
hinge was attached.
48