LG DLE3170W Service Manual page 12

-2. Connecting the Gas Supply
For further assistance, refer to section
. Make certain your dryer is equipped for use with the
type of gas in your laundry room. Dryer is equipped
at the factory for Natural Gas with a
connection.
2. Remove the shipping cap from the gas connection
at the rear of the dryer. Make sure you do not
damage the pipe thread when removing the cap.
1 New Stainless Steel Flexible Connector - Use
only if allowed by local codes (Use Design
A.G.A. Certified Connector)
2 / NPT Pipe Plug
1
8
(for checking inlet gas pressure)
3 Equipment Shut-Off Valve-Installed within 6
(1.8 m) of dryer
Connecting gas dryers on Owner's Manual
3. Connect to gas supply pipe using a new flexible
/ Ó NPT gas
3
4. Tighten all connections securely. Turn on gas and
8
5. For LP (Liquefied Petroleum) gas connection, refer
1
2
5
3
4
12
stainless steel connector.
check all pipe connections (internal and external) for
gas leaks with a non-corrosive leak detection fluid.
to section on Gas Requirements.
4 Black Iron Pipe
Shorter than 20 (6.1 m) - Use
Longer than 20 (6.1 m) - Use
5 / NPT Gas Connection
3
8
3 / pipe
8
/ pipe
1
2