Configuring The Madiface Xt; Settings Dialog - Main Tab - RME Audio MADIface XT User Manual

7. Configuring the MADIface XT

7.1 Settings Dialog – Main Tab
Configuration of the MADIface XT is done via its own settings dialog. The panel 'Settings' can
be opened:
• by clicking on the hammer/flame symbol in the Task Bar's notification area
The mixer of the MADIface XT, TotalMix FX, can be opened:
• by clicking on the DSP symbol in the Task Bar's notification area
The HDSPe hardware offers a number of helpful, well thought-of practical functions and options
which affect how the card operates - it can be configured to suit many different requirements.
The following is available in the 'Settings' dialog:
• Latency
• WDM Device Configuration
• Current sample rate
• Synchronization behaviour
• Configuration of digital I/Os
• Input selection
• State of input and output
Any changes made in the Settings
dialog are applied immediately -
confirmation (e.g. by clicking on OK or
exiting the dialog) is not required.
However, settings should not be
changed during playback or record if it
can be avoided, as this can cause
unwanted noises.
Also, please note that even in 'Stop'
mode, several programs keep the
recording and playback devices open,
which means that any new settings
might not be applied immediately.
The status displays at the bottom of the
dialog box give the user precise
information about the current status of
the system, and the status of all digital
signals.
The tab About provides information
about the current driver version of the
MADIface XT. The USB driver also has
the options Lock Registry and Enable
MMCSS for ASIO on this page (see tab
Global).
User's Guide MADIface XT © RME
13