Telefunken TF-1593 Instruction Manual page 3

Instruction manual
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer to the
manual. Keep the manual for future use.
• Do not hit or drop the unit
• Do not expose the unit to vibration, direct
sunlight, too high or low temperatures or
humidity.
• Do not disassemble the unit yourselves
Refer servicing to qualified service personnel
All the illustrations in this manual are
schematic images, which may differ from
actual objects.
Power supply
Battery operation
• Insert 2 АAA (UM-4) batteries (not included)
to the terminals inside the battery
compartment according to the polarity marks
(+ and -). Your set will not work normally from
the battery supply, but there is now the
advantage that, in case of a mains current
failure or power outage, your clock will
continue to work. The clock display will not
light up, the clock time and alarm setting will
be held in the clock memory by the battery
back-up system.
This enables you to move the set from place
to place without re-setting the clock every time.
The battery back-up system is only meant to
be used for short-term power failures. For
longer durations the batteries may become
exhausted or there may be some deviation in
accuracy.
• When the batteries are exhausted, they
should be removed from the set to prevent
leakage. If you do not wish to take advantage
of the battery back-up system, your set will
work normally without batteries. However, if
disconnected from the mains, the clock
figures will flash when the mains are
reconnected and you must re-set the clock.
AС operation
• The appliance is for household use only.
• Before the first connecting of the appliance
3
check that the voltage indicated on the rating
label corresponds to the mains voltage in your
location.
• Insert the plug into the electrical outlet.
• The set is now working as an electronic
clock.
General operations
Backlight brightness
• Press the SNOOZE button
to adjust the display backlight brightness
level (high, low or off).
Setting the clock
• In standby mode press and hold the
(SET) button. The display will start to flash.
• Press the HR. button
to increase the HOUR. You can press and
hold the button to increase the number quickly.
• Press the MIN. button
to increase the MINUTES. You can press and
hold the button to increase the number quickly.
• Once time is set correctly, press the
SET button again to confirm.
Setting the alarm
• In stanbdy mode press and hold either
AL1 or AL2 buttons. The display will start to flash.
• Press the HR. and MIN. buttons
to adjust the alarm time.
• Press the AL1 or AL2 button, then use
the HR. or MIN. to select the alarm signal: bb
(buzzer) or rAd (FM radio).
• Once the alarm is set press the AL1 or
AL2 button respectively to confirm the setting. The
corresponding alarm indicator will light up on the
display.